Airworthiness Directives; Honeywell IC-600 Integrated Avionics Computers, as Installed In, But Not Limited To, Empresa Brasileira de Aeronautica S.A. (EMBRAER) Model EMB-145 Series Airplanes

FederalRegulations

Ask Donna

How this section applies to your facts.

Federal Register › Vol. 64 › 64 FR 1110

This text was captured on Sep 30, 2026. It is a snapshot, not a live feed, so check the official code before relying on it.

Text

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 39

[Docket No. 98-NM-142-AD; Amendment 39-10979; AD 99-01-14]

RIN 2120-AA64

Airworthiness Directives; Honeywell IC-600 Integrated Avionics

Computers, as Installed In, But Not Limited To, Empresa Brasileira de

Aeronautica S.A. (EMBRAER) Model EMB-145 Series Airplanes

AGENCY: Federal Aviation Administration, DOT.

ACTION: Final rule.

-----------------------------------------------------------------------

SUMMARY: This amendment adopts a new airworthiness directive (AD),

applicable to certain Honeywell IC-600 integrated avionics computers,

that requires modification of the integrated avionics computers. This

amendment is prompted by a report of integrated avionics computer

failures, which caused a ``random reset'' condition of the electronic

flight instrument system. The actions specified by this AD are intended

to prevent such ``random reset'' conditions, which could affect the

pilot's ability to control the airplane.

DATES: Effective February 12, 1999.

The incorporation by reference of certain publications listed in

the regulations is approved by the Director of the Federal Register as

of February 12, 1999.

ADDRESSES: The service information referenced in this AD may be

obtained from Honeywell Inc., Business and Commuter Aviation Systems,

Box 29000, Phoenix, Arizona 85038. This information may be examined at

the Federal Aviation Administration (FAA), Transport Airplane

Directorate, Rules Docket, 1601 Lind Avenue, SW., Renton, Washington;

or at the FAA, Transport Airplane Directorate, Los Angeles Aircraft

Certification Office, 3960 Paramount Boulevard, Lakewood, California;

or at the Office of the Federal Register, 800 North Capitol Street,

NW., suite 700, Washington, DC.

FOR FURTHER INFORMATION CONTACT: J. Kirk Baker, Aerospace Engineer,

Systems and Equipment Branch, ANM-130L, FAA, Transport Airplane

Directorate, Los Angeles Aircraft Certification Office, 3960 Paramount

Boulevard, Lakewood, California 90712-4137; telephone (562) 627-5345;

fax (562) 627-5210.

SUPPLEMENTARY INFORMATION: A proposal to amend part 39 of the Federal

Aviation Regulations (14 CFR part 39) to include an airworthiness

directive (AD) that is applicable to certain Honeywell IC-600

integrated avionics computers was published in the Federal Register on

June 3, 1998 (63 FR 30155). That

action proposed to require modification of the integrated avionics

computers.

Comments

Interested persons have been afforded an opportunity to participate

in the making of this amendment. Due consideration has been given to

the comments received.

Request To Limit Applicability

One commenter requests that Learjet Model 45 airplanes be removed

from the applicability of the proposed rule. The commenter indicates

that there was only one Learjet Model 45 airplane with the suspect

Honeywell IC-600 integrated avionics computer that received a standard

certificate of airworthiness, and that airplane has been modified in

accordance with the proposed rule.

The FAA concurs with the commenter's request that the Learjet Model

45 airplanes be removed from the applicability of the final rule. This

decision is based on supporting documentation that there was only one

Learjet Model 45 airplane with the suspect IC-600, and a modified IC-

600 was installed on that airplane before delivery to the customer.

Furthermore, Learjet has incorporated the required modifications into

production. The part numbers related to these airplanes will be removed

from the appropriate sections in the final rule. The Summary and

Applicability sections, as well as paragraph (b) of the final rule,

have been revised accordingly.

Request To Reduce Compliance Time and Revise the Airplane Flight

Manual

One commenter requests that the compliance time for the

modification in the proposed rule be reduced from 6 months to 30 days

so that the unsafe condition is addressed in a more timely manner. The

commenter also requests that a temporary revision to the FAA-approved

Airplane Flight Manual (AFM) be issued in the interim to alert

flightcrews of the potential hazards if the electronic flight

instrument system fails. The commenter states that this is necessary

because the unsafe condition exists today and the flightcrews may be

unaware of the possibility of this potentially catastrophic condition.

The FAA does not concur with the commenter's request. In developing

an appropriate compliance time, the FAA considered the safety

implications, parts availability, and normal maintenance schedules.

Further, the compliance time of 6 months was established with the

operator's, the manufacturer's, and FAA's concurrence. The FAA also has

determined that, without prior notice and opportunity for public

comment, a reduction in the compliance time is not appropriate. In

light of these factors, and in consideration of the amount of time that

has already elapsed since issuance of the proposed rule, the FAA has

determined that further delay of this final rule is not warranted.

However, if additional data are presented that would justify a

reduction in the compliance time, the FAA may consider further

rulemaking on this issue.

With regard to the commenter's request for an AFM revision, the FAA

has considered the potential hazard for temporary loss of flight

guidance and does not consider that hazard to be catastrophic. The

flightcrew's ability to use the standby instruments during the 30-

second rebuild of the display will allow them continued operational

safety. Additionally, it was determined that at no time did the display

present any hazardously misleading information. Therefore, the FAA does

not find it appropriate to require a revision of the AFM. No change to

the final rule is necessary in this regard.

Conclusion

After careful review of the available data, including the comments

noted above, the FAA has determined that air safety and the public

interest require the adoption of the rule with the changes described

previously. The FAA has determined that these changes will neither

increase the economic burden on any operator nor increase the scope of

the AD.

Cost Impact

There are approximately 37 airplanes of the affected design in the

worldwide fleet. The FAA estimates that 19 airplanes of U.S. registry

will be affected by this proposed AD. It will take approximately 2 work

hours per airplane to accomplish the required modification at an

average labor rate of $60 per work hour. Required parts will be

supplied by the manufacturer at no cost to operators. Based on these

figures, the cost impact of the modification required by this AD on

U.S. operators is estimated to be $2,280, or $120 per airplane.

The cost impact figure discussed above is based on assumptions that

no operator has yet accomplished any of the requirements of this AD

action, and that no operator would accomplish those actions in the

future if this AD were not adopted.

Regulatory Impact

The regulations adopted herein will not have substantial direct

effects on the States, on the relationship between the national

government and the States, or on the distribution of power and

responsibilities among the various levels of government. Therefore, in

accordance with Executive Order 12612, it is determined that this final

rule does not have sufficient federalism implications to warrant the

preparation of a Federalism Assessment.

For the reasons discussed above, I certify that this action (1) is

not a ``significant regulatory action'' under Executive Order 12866;

(2) is not a ``significant rule'' under DOT Regulatory Policies and

Procedures (44 FR 11034, February 26, 1979); and (3) will not have a

significant economic impact, positive or negative, on a substantial

number of small entities under the criteria of the Regulatory

Flexibility Act. A final evaluation has been prepared for this action

and it is contained in the Rules Docket. A copy of it may be obtained

from the Rules Docket at the location provided under the caption

ADDRESSES.

List of Subjects in 14 CFR Part 39

Air transportation, Aircraft, Aviation safety, Incorporation by

reference, Safety.

Adoption of the Amendment

Accordingly, pursuant to the authority delegated to me by the

Administrator, the Federal Aviation Administration amends part 39 of

the Federal Aviation Regulations (14 CFR part 39) as follows:

PART 39--AIRWORTHINESS DIRECTIVES

1. The authority citation for part 39 continues to read as follows:

Authority: 49 U.S.C. 106(g), 40113, 44701.

Sec. 39.13 [Amended]

2. Section 39.13 is amended by adding the following new

airworthiness directive:

99-01-14 Honeywell: Amendment 39-10979. Docket 98-NM-142-AD.

Applicability: Honeywell IC-600 integrated avionics computers

having part numbers 7017000-82401, -82402, -82403, -83401, -83402,

and -83403, as installed in, but not limited to, EMBRAER Model EMB-

145 series airplanes.

Note 1: This AD applies to Honeywell IC-600 integrated avionics

computers having part numbers 7017000-82401, -82402, -82403, -83401,

-83402, and -83403; as installed in any airplane, regardless of

whether the airplane has been modified, altered, or repaired in the

area subject to the requirements of this AD. For airplanes that have

been modified, altered, or repaired so that the performance of the

requirements of this AD is affected, the owner/operator must request

approval for an alternative method of compliance in accordance with

paragraph (c)

of this AD. The request should include an assessment of the effect

of the modification, alteration, or repair on the unsafe condition

addressed by this AD; and, if the unsafe condition has not been

eliminated, the request should include specific proposed actions to

address it.

Compliance: Required as indicated, unless accomplished

previously.

To prevent a ``random reset'' condition of the electronic flight

instrument system, which could affect the pilot's ability to control

the airplane, accomplish the following:

(a) Within 6 months after the effective date of this AD, modify

the IC-600 integrated avionics computer, in accordance with

Honeywell Service Bulletin 7017000-22-43, dated March 24, 1998.

(b) As of the effective date of this AD, no person shall install

a Honeywell IC-600 integrated avionics computer having part number

7017000-82401, -82402, -82403, -83401, -83402, or -83403 on any

airplane; unless it has been modified in accordance with Honeywell

Service Bulletin 7017000-22-43, dated March 24, 1998.

(c) An alternative method of compliance or adjustment of the

compliance time that provides an acceptable level of safety may be

used if approved by the Manager, Los Angeles Aircraft Certification

Office (ACO), FAA, Transport Airplane Directorate. Operators shall

submit their requests through an appropriate FAA Principal

Maintenance Inspector, who may add comments and then send it to the

Manager, Los Angeles ACO.

Note 2: Information concerning the existence of approved

alternative methods of compliance with this AD, if any, may be

obtained from the Los Angeles ACO.

(d) Special flight permits may be issued in accordance with

sections 21.197 and 21.199 of the Federal Aviation Regulations (14

CFR 21.197 and 21.199) to operate the airplane to a location where

the requirements of this AD can be accomplished.

(e) The modification shall be done in accordance with Honeywell

Service Bulletin 7017000-22-43, dated March 24, 1998. This

incorporation by reference was approved by the Director of the

Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR part

51. Copies may be obtained from Honeywell Inc., Business and

Commuter Aviation Systems, Box 29000, Phoenix, Arizona 85038. Copies

may be inspected at the FAA, Transport Airplane Directorate, 1601

Lind Avenue, SW., Renton, Washington; or at the FAA, Transport

Airplane Directorate, Los Angeles Aircraft Certification Office,

3960 Paramount Boulevard, Lakewood, California; or at the Office of

the Federal Register, 800 North Capitol Street, NW., suite 700,

Washington, DC.

(f) This amendment becomes effective on February 12, 1999.

Issued in Renton, Washington, on December 28, 1998.

Darrell M. Pederson,

Acting Manager, Transport Airplane Directorate, Aircraft Certification

Service.

[FR Doc. 99-48 Filed 1-7-99; 8:45 am]

BILLING CODE 4910-13-U

This is a copy of a public record, reproduced as it was published. It is not legal advice, and it may not be the version a court would rely on. Check the official source before you cite it.

A word about cookies

We need a few to keep you signed in and the library working. The rest help us see which pages people use and where they get stuck. They stay off unless you say yes.