Airworthiness Directives; Airbus Model A319, A320, and A321 Series Airplanes

FederalRegulations

Ask Donna

How this section applies to your facts.

Federal Register › Vol. 64 › 64 FR 1106

This text was captured on Sep 30, 2026. It is a snapshot, not a live feed, so check the official code before relying on it.

Text

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 39

[Docket No. 98-NM-07-AD; Amendment 39-10978; AD 99-01-13]

RIN 2120-AA64

Airworthiness Directives; Airbus Model A319, A320, and A321

Series Airplanes

AGENCY: Federal Aviation Administration, DOT.

ACTION: Final rule.

-----------------------------------------------------------------------

SUMMARY: This amendment adopts a new airworthiness directive (AD),

applicable to certain Airbus Model A319, A320, and A321 series

airplanes, that requires modification of the airplane wiring to

separate the electrical inputs sent by the engine interface units (EIU)

to certain probe heat computers (PHC). This amendment is prompted by

the issuance of mandatory continuing airworthiness information by a

foreign civil airworthiness authority. The actions specified by this AD

are intended to prevent simultaneous loss of heating to pitot probes 1

and 3, which could result in incorrect airspeed indications to both the

pilot's and first officer's airspeed indication systems. Malfunction of

these systems could result in reduced controllability of the airplane.

DATES: Effective February 12, 1999.

The incorporation by reference of certain publications listed in

the regulations is approved by the Director of the Federal Register as

of February 12, 1999.

ADDRESSES: The service information referenced in this AD may be

obtained from Airbus Industrie, 1 Rond Point Maurice Bellonte, 31707

Blagnac Cedex, France. This information may be examined at the Federal

Aviation Administration (FAA), Transport Airplane Directorate, Rules

Docket, 1601 Lind Avenue, SW., Renton, Washington; or at the Office of

the Federal Register, 800 North Capitol Street, NW., suite 700,

Washington, DC.

FOR FURTHER INFORMATION CONTACT: Norman B. Martenson, Manager,

International Branch, ANM-116, FAA, Transport Airplane Directorate,

1601 Lind Avenue, SW., Renton, Washington 98055-4056; telephone (425)

227-2110; fax (425) 227-1149.

SUPPLEMENTARY INFORMATION: A proposal to amend part 39 of the Federal

Aviation Regulations (14 CFR part 39) to include an airworthiness

directive (AD) that is applicable to certain Airbus Model A319, A320,

and A321 series airplanes was published as a supplemental notice of

proposed rulemaking (NPRM) in the Federal Register on October 27, 1998

(63 FR 57263). That action proposed to require modification of the

airplane wiring to separate the electrical inputs sent by the engine

interface units (EIU) to certain probe heat computers (PHC).

Comments

Interested persons have been afforded an opportunity to participate

in the making of this amendment. Due consideration has been given to

the three comments received.

All of the commenters support the proposed rule.

Conclusion

After careful review of the available data, including the comments

noted above, the FAA has determined that air safety and the public

interest require the adoption of the rule as proposed.

Cost Impact

The FAA estimates that 150 airplanes of U.S. registry will be

affected by this AD.

It will take approximately 3 work hours per airplane to accomplish

the required modification (including testing), at an average labor rate

of $60 per work hour. Required parts will be provided by the

manufacturer at no cost to the operators. Based on these figures, the

cost impact of this AD on U.S. operators is estimated to be $27,000, or

$180 per airplane.

Should an operator be required to re-test modified wiring, it will

take approximately 1 additional work hour per airplane to accomplish

the test, at an average labor rate of $60 per work hour. Based on these

figures, the cost impact of any necessary re-test required by this AD

on U.S. operators is estimated to be $60 per airplane.

The cost impact figures discussed above are based on assumptions

that no operator has yet accomplished any of the requirements of this

AD action, and that no operator would accomplish those actions in the

future if this AD were not adopted.

Regulatory Impact

The regulations adopted herein will not have substantial direct

effects on the States, on the relationship between the national

government and the States, or on the distribution of power and

responsibilities among the various levels of government. Therefore, in

accordance with Executive Order 12612, it is determined that this final

rule does not have sufficient federalism implications to warrant the

preparation of a Federalism Assessment.

For the reasons discussed above, I certify that this action (1) is

not a ``significant regulatory action'' under Executive Order 12866;

(2) is not a ``significant rule'' under DOT Regulatory Policies and

Procedures (44 FR 11034, February 26, 1979); and (3) will not have a

significant economic impact, positive or negative, on a substantial

number of small entities under the criteria of the Regulatory

Flexibility Act. A final evaluation has been prepared for this action

and it is contained in the Rules Docket. A copy of it may be obtained

from the Rules Docket at the location provided under the caption

ADDRESSES.

List of Subjects in 14 CFR Part 39

Air transportation, Aircraft, Aviation safety, Incorporation by

reference, Safety.

Adoption of the Amendment

Accordingly, pursuant to the authority delegated to me by the

Administrator, the Federal Aviation Administration amends part 39 of

the Federal Aviation Regulations (14 CFR part 39) as follows:

PART 39--AIRWORTHINESS DIRECTIVES

1. The authority citation for part 39 continues to read as follows:

Authority: 49 U.S.C. 106(g), 40113, 44701.

Sec. 39.13 [Amended]

2. Section 39.13 is amended by adding the following new

airworthiness directive:

99-01-13 Airbus Industrie: Amendment 39-10978. Docket 98-NM-07-AD.

Applicability: Model A319, A320, and A321 series airplanes;

excluding airplanes on which Airbus Modification 26403 or Airbus

Service Bulletin A320-30-1036, Revision 02, dated February 4, 1998,

has been accomplished; certificated in any category.

Note 1: This AD applies to each airplane identified in the

preceding applicability provision, regardless of whether it has been

otherwise modified, altered, or repaired in the area subject to the

requirements of this AD. For airplanes that have been modified,

altered, or repaired so that the performance of the requirements of

this AD is affected, the owner/operator must request approval for an

alternative method of compliance in accordance with paragraph (b) of

this AD. The request should include an assessment of the effect of

the modification, alteration, or repair on the unsafe condition

addressed by this AD; and, if the unsafe condition has not been

eliminated, the request should include specific proposed actions to

address it.

Compliance: Required as indicated, unless accomplished

previously.

To prevent simultaneous loss of heating to pitot probes 1 and 3,

which could result in incorrect airspeed indications to both the

pilot's and first officer's airspeed indication systems, and reduced

controllability of the airplane, accomplish the following:

(a) Within 6 months after the effective date of this AD, modify

the airplane wiring to separate the electrical inputs sent by the

engine interface units to probe heat computers 1 and 3, and test the

modified wiring; in accordance with the service bulletin referenced

in paragraph (a)(1) or (a)(2) of this AD, as applicable.

(1) For airplanes equipped with engines manufactured by CFM

International (CFMI): Modify and test in accordance with Airbus

Service Bulletin A320-30-1036, dated May 9, 1997; or Airbus Service

Bulletin A320-30-1036, Revision 02, dated February 4, 1998.

Note 2: For airplanes equipped with CFMI engines: Accomplishment

of the modification and test in accordance with Airbus Service

Bulletin A320-30-1036, Revision 01, dated July 7, 1997, is

considered acceptable for compliance with paragraph (a)(1) of this

AD.

(2) For airplanes equipped with engines manufactured by

International Aero Engines AG (IAE): Modify and test in accordance

with Airbus Service Bulletin A320-30-1036, Revision 02, dated

February 4, 1998.

Note 3: For airplanes equipped with IAE engines: Accomplishment

of the modification in accordance with Airbus Service Bulletin A320-

30-1036, dated May 9, 1997, or Revision 01, dated July 7, 1997,

prior to the effective date of this AD, is considered acceptable for

compliance with the modification specified by paragraph (a)(2) of

this AD, provided that the modification is tested in accordance with

the procedures specified in Airbus Service Bulletin A320-30-1036,

Revision 02, dated February 4, 1998.

(b) An alternative method of compliance or adjustment of the

compliance time that provides an acceptable level of safety may be

used if approved by the Manager, International Branch, ANM-116, FAA,

Transport Airplane Directorate. Operators shall submit their

requests through an appropriate FAA Principal Maintenance Inspector,

who may add comments and then send it to the Manager, International

Branch, ANM-116.

Note 4: Information concerning the existence of approved

alternative methods of compliance with this AD, if any, may be

obtained from the International Branch, ANM-116.

(c) Special flight permits may be issued in accordance with

sections 21.197 and 21.199 of the Federal Aviation Regulations (14

CFR 21.197 and 21.199) to operate the airplane to a location where

the requirements of this AD can be accomplished.

(d) The modification and test shall be done in accordance with

Airbus Service Bulletin A320-30-1036, dated May 9, 1997; or Airbus

Service Bulletin A320-30-1036, Revision 02, dated February 4, 1998,

as applicable. This incorporation by reference was approved by the

Director of the Federal Register in accordance with 5 U.S.C. 552(a)

and 1 CFR part 51. Copies may be obtained from Airbus Industrie, 1

Rond Point Maurice Bellonte, 31707 Blagnac Cedex, France. Copies may

be inspected at the FAA, Transport Airplane Directorate, 1601 Lind

Avenue, SW., Renton, Washington; or at the Office of the Federal

Register, 800 North Capitol Street, NW., suite 700, Washington, DC.

Note 5: The subject of this AD is addressed in French

airworthiness directives 97-203-102(B)R1 and 98-152-114(B), both

dated April 8, 1998.

(e) This amendment becomes effective on February 12, 1999.

Issued in Renton, Washington, on December 28, 1998.

Darrell M. Pederson,

Acting Manager, Transport Airplane Directorate, Aircraft Certification

Service.

[FR Doc. 99-50 Filed 1-7-99; 8:45 am]

BILLING CODE 4910-13-U

This is a copy of a public record, reproduced as it was published. It is not legal advice, and it may not be the version a court would rely on. Check the official source before you cite it.

A word about cookies

We need a few to keep you signed in and the library working. The rest help us see which pages people use and where they get stuck. They stay off unless you say yes.