§ 178.33-6 Manufacture.
FederalRegulations
Ask Donna
How this section applies to your facts.
Title 49—Transportation > Subtitle B—Other Regulations Relating to Transportation > CHAPTER I—PIPELINE AND HAZARDOUS MATERIALS SAFETY ADMINISTRATION, DEPARTMENT OF TRANSPORTATION > SUBCHAPTER C—HAZARDOUS MATERIALS REGULATIONS > PART 178—SPECIFICATIONS FOR PACKAGINGS > Subpart B—Specifications for Inside Containers, and Linings
Text
(a) By appliances and methods that will assure uniformity of completed containers; dirt and scale to be removed as necessary; no defect acceptable that is likely to weaken the finished container appreciably; reasonably smooth and uniform surface finish required.
(b) Seams when used must be as follows:
(1) Circumferential seams: By welding, swedging, brazing, soldering, or double seaming.
(2) Side seams: By welding, brazing, or soldering.
(c) Ends: The ends shall be of pressure design.
[29 FR 18823, Dec. 29, 1964, as amended by Order 71, 31 FR 9074, July 1, 1966. Redesignated at 32 FR 5606, Apr. 5, 1967]
This is a copy of a public record, reproduced as it was published. It is not legal advice, and it may not be the version a court would rely on. Check the official source before you cite it.