Airworthiness Directives; Boeing Model 737 Series Airplanes

FederalRegulations

Ask Donna

How this section applies to your facts.

Federal Register › Vol. 62 › 62 FR 15

This text was captured on Sep 30, 2026. It is a snapshot, not a live feed, so check the official code before relying on it.

Text

DEPARTMENT OF TRANSPORTATION

14 CFR Part 39

[Docket No. 96-NM-266-AD; Amendment 39-9871; AD 96-26-07]

RIN 2120-AA64

Airworthiness Directives; Boeing Model 737 Series Airplanes

AGENCY: Federal Aviation Administration, DOT.

ACTION: Final rule; request for comments.

-----------------------------------------------------------------------

SUMMARY: This amendment adopts a new airworthiness directive (AD) that

is applicable to all Boeing Model 737 series airplanes. This action

requires revising the FAA-approved Airplane Flight Manual (AFM) to

include procedures that will enable the flight crew to take appropriate

action to maintain control of the airplane during an uncommanded yaw or

roll condition, and to correct a jammed or restricted flight control

condition. This amendment is prompted by an FAA determination that such

procedures currently are not defined adequately in the AFM for these

airplanes. The actions specified in this AD are intended to ensure that

the flight crew is advised of the potential hazard associated with a

jammed or restricted flight control condition and of the procedures

necessary to address it.

DATES: Effective January 17, 1997.

Comments for inclusion in the Rules Docket must be received on or

before March 3, 1997.

ADDRESSES: Submit comments in triplicate to the Federal Aviation

Administration (FAA), Transport Airplane Directorate, ANM-103,

Attention: Rules Docket No. 96-NM-266-AD, 1601 Lind Avenue, SW.,

Renton, Washington 98055-4056.

The information concerning this amendment may be obtained from or

examined at the FAA, Transport Airplane Directorate, 1601 Lind Avenue,

SW., Renton, Washington.

FOR FURTHER INFORMATION CONTACT: Les Berven, Flight Test Pilot, Flight

Test Branch, ANM-160S, Seattle Aircraft Certification Office, FAA,

Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton,

Washington 98055-4056; telephone (206) 227-2666; fax (206) 227-1181.

SUPPLEMENTARY INFORMATION: As part of its Continuing Operational Safety

Program, the FAA has become aware of new information related to the

safety of Boeing Model 737 series airplanes. Recent tests of the main

rudder power control unit (PCU), conducted at Boeing, demonstrated a

potential failure scenario that was previously unknown. These tests

revealed that, if the secondary slide of the PCU jams in certain

positions, rudder pedal input can cause deformation in the linkage

leading to the primary and secondary slides of the servo valve of the

main rudder PCU. This situation could result in rudder deflection in

the opposite direction of the rudder command, and a jammed rudder.

Other Relevant Rulemaking

The conditions described previously were addressed previously in AD

96-23-51, amendment 39-9818 (61 FR 59317, November 22, 1996), which is

applicable to all Boeing Model 737 series airplanes. That AD requires

repetitive tests to verify proper operation of the rudder power control

unit (PCU), and replacement of the PCU, if necessary. The actions

specified by that AD are intended to prevent rudder motion in the

opposite direction of the rudder command.

FAA's Findings

As a result of analysis related to the previously prescribed tests,

the FAA finds that certain procedures should be included in the FAA-

approved Airplane Flight Manual (AFM) for Model 737 series airplanes to

enable the flight crew to take appropriate action to maintain control

of the airplane during an uncommanded yaw or roll condition, and to

correct a jammed or restricted flight control condition. The FAA has

determined that such procedures currently are not defined adequately in

the AFM for these airplanes.

Explanation of the Requirements of the Rule

Since an unsafe condition has been identified that is likely to

exist or develop on other Boeing Model 737 series airplanes of the same

type design, this AD is being issued to ensure that the flight crew is

advised of the potential hazard associated with a jammed or restricted

flight control condition and of the procedures necessary to address it.

This AD requires revising the AFM to include procedures that will

enable the flight crew to take appropriate action to maintain control

of the airplane during an uncommanded yaw or roll condition, and to

correct a jammed or restricted flight control condition.

Determination of Rule's Effective Date

Since a situation exists that requires the immediate adoption of

this regulation, it is found that notice and opportunity for prior

public comment hereon are impracticable, and that good cause exists for

making this amendment effective in less than 30 days.

Comments Invited

Although this action is in the form of a final rule that involves

requirements affecting flight safety and, thus, was not preceded by

notice and an opportunity for public comment, comments are invited on

this rule. Interested persons are invited to comment on this rule by

submitting such written data, views, or arguments as they may desire.

Communications shall identify the Rules Docket number and be submitted

in triplicate to the address specified under the caption ADDRESSES. All

communications received on or before the closing date for comments will

be considered, and this rule may be amended in light of the comments

received. Factual information that supports the commenter's ideas and

suggestions is extremely helpful in evaluating the effectiveness of the

AD action and determining whether additional rulemaking action would be

needed.

Comments are specifically invited on the overall regulatory,

economic, environmental, and energy aspects of the rule that might

suggest a need to modify the rule. All comments submitted will be

available, both before and after the closing date for comments, in the

Rules Docket for examination by interested persons. A report that

summarizes each FAA-public contact concerned with the substance of this

AD will be filed in the Rules Docket.

Commenters wishing the FAA to acknowledge receipt of their comments

submitted in response to this rule must submit a self-addressed,

stamped postcard on which the following statement is made: ``Comments

to Docket Number 96-NM-266-AD.'' The postcard will be date stamped and

returned to the commenter.

Regulatory Impact

The regulations adopted herein will not have substantial direct

effects on the States, on the relationship between the national

government and the States, or on the distribution of power and

responsibilities among the various levels of government. Therefore, in

accordance with Executive Order 12612, it is determined that this final

rule does

not have sufficient federalism implications to warrant the preparation

of a Federalism Assessment.

The FAA has determined that this regulation is an emergency

regulation that must be issued immediately to correct an unsafe

condition in aircraft, and that it is not a ``significant regulatory

action'' under Executive Order 12866. It has been determined further

that this action involves an emergency regulation under DOT Regulatory

Policies and Procedures (44 FR 11034, February 26, 1979). If it is

determined that this emergency regulation otherwise would be

significant under DOT Regulatory Policies and Procedures, a final

regulatory evaluation will be prepared and placed in the Rules Docket.

A copy of it, if filed, may be obtained from the Rules Docket at the

location provided under the caption ADDRESSES.

List of Subjects in 14 CFR Part 39

Air transportation, Aircraft, Aviation safety, Safety.

Adoption of the Amendment

Accordingly, pursuant to the authority delegated to me by the

Administrator, the Federal Aviation Administration amends part 39 of

the Federal Aviation Regulations (14 CFR part 39) as follows:

PART 39--AIRWORTHINESS DIRECTIVES

1. The authority citation for part 39 continues to read as follows:

Authority: 49 U.S.C. 106(g), 40113, 44701.

Sec. 39.13 [Amended]

2. Section 39.13 is amended by adding the following new

airworthiness directive:

96-26-07 BOEING: Amendment 39-9871. Docket 96-NM-266-AD.

Applicability: All Model 737 series airplanes, certificated in

any category.

Note 1: This AD applies to each airplane identified in the

preceding applicability provision, regardless of whether it has been

modified, altered, or repaired in the area subject to the

requirements of this AD. For airplanes that have been modified,

altered, or repaired so that the performance of the requirements of

this AD is affected, the owner/operator must request approval for an

alternative method of compliance in accordance with paragraph (b) of

this AD. The request should include an assessment of the effect of

the modification, alteration, or repair on the unsafe condition

addressed by this AD; and, if the unsafe condition has not been

eliminated, the request should include specific proposed actions to

address it.

Compliance: Required as indicated, unless accomplished

previously.

To ensure that the flight crew is advised of the potential

hazard associated with jammed or restricted flight controls and of

the procedures necessary to address it, accomplish the following:

(a) Within 30 days after the effective date of this AD,

accomplish paragraphs (a)(1) and (a)(2) of this AD.

(1) Revise the Emergency Procedures Section of the FAA-approved

Airplane Flight Manual (AFM) to include the following recall item,

which will enable the flight crew to take appropriate action to

maintain control of the airplane during an uncommanded yaw or roll

condition. This may be accomplished by inserting a copy of this AD in

the AFM.

``UNCOMMANDED YAW OR ROLL

RECALL

Maintain control of the airplane with all available flight

controls. If roll is uncontrollable, immediately reduce angle of

attack and increase airspeed. Do not attempt to maintain altitude

until control is recovered. If engaged, disconnect autopilot and

autothrottle.''

(2) Revise the section entitled ``JAMMED FLIGHT CONTROLS'' of

the Normal Procedures Section (for Model 737-100 and -200 series

airplanes) or the Non-Normal Procedures Section (for Model 737-300,

-400, and -500 series airplanes), as applicable, of the FAA-approved

AFM to include the following procedures, which will enable the

flight crew to take appropriate action to maintain control of the

airplane and to correct a jammed or restricted flight control

condition. This may be accomplished by inserting a copy of this AD

in the AFM.

``JAMMED FLIGHT CONTROLS

JAMMED OR RESTRICTED ELEVATOR OR AILERON:

In the event of a jammed elevator or aileron, do not hesitate to

apply additional force to maintain control of the airplane. Do not

turn off any flight control switches unless the faulty control is

positively identified. Manual trim may be used to offload control

forces.

JAMMED OR RESTRICTED RUDDER:

If the rudder pedals will not move to the pilot commanded

position, or if the pedals are deflected in one direction and

jammed, maintain control of the airplane with all available flight

controls. Disengage the autopilot and autothrottle. Use maximum

force (combined effort by both pilots) to overpower the rudder

system.

After establishing control of the aircraft, check rudder pedal

position. If the rudder pedals have centered, accomplish a normal

descent, approach, and landing. If the rudder pedals remain jammed

and are deflected to a degree that significantly affects the

controllability of the airplane, select System B flight control

switch to STBY RUD. If this action clears the jam/deflection, make a

normal approach and landing, noting that rudder control may be

limited. If moving the System B flight control switch to STBY RUD

does not clear the jam, select System A flight control switch to

off. If pedals do not center, select System B flight control switch

to off. Make approach and landing with flaps 15 at VREF flaps

15. The crosswind capability of the airplane will be greatly

reduced.

YAW DAMPER:

The yaw damper is a separate control and provides a limited

rudder movement in opposition to the yaw rate of the airplane.

Rudder (yaw damper) indicator displacement indicates yaw damper

operation. Yaw damper light illuminates amber when the yaw damper is

not engaged.

(b) An alternative method of compliance or adjustment of the

compliance time that provides an acceptable level of safety may be

used if approved by the Manager, Seattle Aircraft Certification

Office (ACO), FAA, Transport Airplane Directorate. Operators shall

submit their requests through an appropriate FAA Principal

Operations Inspector, who may add comments and then send it to the

Manager, Seattle ACO.

Note 2: Information concerning the existence of approved

alternative methods of compliance with this AD, if any, may be

obtained from the Seattle ACO.

(c) Special flight permits may be issued in accordance with

sections 21.197 and 21.199 of the Federal Aviation Regulations (14

CFR 21.197 and 21.199) to operate the airplane to a location where

the requirements of this AD can be accomplished.

(d) This amendment becomes effective on January 17, 1997.

Issued in Renton, Washington, on December 23, 1996.

S.R. Miller,

Acting Manager, Transport Airplane Directorate, Aircraft Certification

Service.

[FR Doc. 96-33104 Filed 12-30-96; 10:25 am]

BILLING CODE 4910-13-U

This is a copy of a public record, reproduced as it was published. It is not legal advice, and it may not be the version a court would rely on. Check the official source before you cite it.

A word about cookies

We need a few to keep you signed in and the library working. The rest help us see which pages people use and where they get stuck. They stay off unless you say yes.

Airworthiness Directives; Boeing Model 737 Series Airplanes · 62 FR 15 | Frix