Airworthiness Directives; Dassault Aviation Model Mystere-Falcon 50 Series Airplanes

FederalRegulations

Ask Donna

How this section applies to your facts.

Federal Register › Vol. 60 › 60 FR 3

This text was captured on Sep 30, 2026. It is a snapshot, not a live feed, so check the official code before relying on it.

Text

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 39

[Docket No. 94-NM-227-AD; Amendment 39-9114; AD 95-01-03]

Airworthiness Directives; Dassault Aviation Model Mystere-Falcon

50 Series Airplanes

AGENCY: Federal Aviation Administration, DOT.

ACTION: Final rule; request for comments.

-----------------------------------------------------------------------

SUMMARY: This amendment adopts a new airworthiness directive (AD) that

is applicable to certain Dassault Aviation Model Mystere-Falcon 50

series airplanes. This action requires measurement of the clearance

between the electrical bundles in the left-hand cabinet of the

electrical panel and the counterbalancing actuator of the passenger

door, and rerouting and clamping the wire bundles, if necessary. This

amendment is prompted by a report of damage of the wire bundles between

the actuator of the passenger door and the left-hand cabinet of the

electrical panel. The actions specified in this AD are intended to

prevent an electrical fire due to damage of the electrical wire

bundles.

DATES: Effective on January 18, 1995.

The incorporation by reference of certain publications listed in

the regulations is approved by the Director of the Federal Register as

of January 18, 1995.

Comments for inclusion in the Rules Docket must be received on or

before March 6, 1995.

ADDRESSES: Submit comments in triplicate to the Federal Aviation

Administration (FAA), Transport Airplane Directorate, ANM-103,

Attention: Rules Docket No. 94-NM-227-AD, 1601 Lind Avenue, SW.,

Renton, Washington 98055-4056.

The service information referenced in this AD may be

obtained from Falcon Jet Corporation, P.O. Box 967, Little Rock,

Arkansas 72203-0967. This information may be examined at the FAA,

Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton,

Washington; or at the Office of the Federal Register, 800 North Capitol

Street, NW., suite 700, Washington, DC.

FOR FURTHER INFORMATION CONTACT: Stephen Slotte, Aerospace Engineer,

Standardization Branch, ANM-113, FAA, Transport Airplane Directorate,

1601 Lind Avenue, SW., Renton, Washington 98055-4056; telephone (206)

227-2797; fax (206) 227-1320.

SUPPLEMENTARY INFORMATION: The Direction Generale de l'Aviation Civile

(DGAC), which is the airworthiness authority for France, recently

notified the FAA that an unsafe condition may exist on certain Dassault

Aviation Model Mystere-Falcon 50 series airplanes. The DGAC advises

that it has received a report of damage of the wire bundles between the

actuator of the passenger door and the left-hand cabinet of the

electrical panel. Investigation revealed that the cause of this damage

may be attributed to insufficient clearance between the left-hand

cabinet and the counterbalancing actuator of the passenger door. This

condition, if not corrected, could result in the potential for an

electrical fire due to damage of the electrical wire bundles.

Dassault Aviation has issued Alert Service Bulletin F50-A243 (F50-

A39-1), Revision 1, dated November 10, 1994, which describes procedures

for measuring the clearance between the electrical bundles in the left-

hand cabinet and the counterbalancing actuator of the passenger door,

and rerouting and clamping the wire bundles if the clearance is outside

the limits specified in the alert service bulletin. The French DGAC

classified this alert service bulletin as mandatory and issued French

airworthiness directive 94-238-015(B), dated November 9, 1994, in order

to assure the continued airworthiness of these airplanes in France.

This airplane model is manufactured in France and is type

certificated for operation in the United States under the provisions of

section 21.29 of the Federal Aviation Regulations (14 CFR 21.29) and

the applicable bilateral airworthiness agreement. Pursuant to this

bilateral airworthiness agreement, the French DGAC has kept the FAA

informed of the situation described above. The FAA has examined the

findings of the French DGAC, reviewed all available information, and

determined that AD action is necessary for products of this type design

that are certificated for operation in the United States.

Since an unsafe condition has been identified that is likely to

exist or develop on other airplanes of the same type design registered

in the United States, this AD is being issued to prevent an electrical

fire due to damage of the electrical wire bundles. This AD requires

measurement of the clearance between the electrical bundles in the

left-hand cabinet and the counterbalancing actuator of the passenger

door, and rerouting and clamping of the wire bundles, if necessary. The

actions are required to be accomplished in accordance with the alert

service bulletin described previously.

As a result of recent communications with the Air Transport

Association (ATA) of America, the FAA has learned that, in general,

some operators may misunderstand the legal effect of AD's on airplanes

that are identified in the applicability provision of the AD, but that

have been altered or repaired in the area addressed by the AD. The FAA

points out that all airplanes identified in the applicability provision

of an AD are legally subject to the AD. If an airplane has been altered

or repaired in the affected area in such a way as to affect compliance

with the AD, the owner or operator is required to obtain FAA approval

for an alternative method of compliance with the AD, in accordance with

the paragraph of each AD that provides for such approvals. A note has

been included in this rule to clarify this requirement.

Since a situation exists that requires the immediate adoption of

this regulation, it is found that notice and opportunity for prior

public comment hereon are impracticable, and that good cause exists for

making this amendment effective in less than 30 days.

Comments Invited

Although this action is in the form of a final rule that involves

requirements affecting flight safety and, thus, was not preceded by

notice and an opportunity for public comment, comments are invited on

this rule. Interested persons are invited to comment on this rule by

submitting such written data, views, or arguments as they may desire.

Communications shall identify the Rules Docket number and be submitted

in triplicate to the address specified under the caption ADDRESSES. All

communications received on or before the closing date for comments will

be considered, and this rule may be amended in light of the comments

received. Factual information that supports the commenter's ideas and

suggestions is extremely helpful in evaluating the effectiveness of the

AD action and determining whether additional rulemaking action would be

needed.

Comments are specifically invited on the overall regulatory,

economic, environmental, and energy aspects of the rule that might

suggest a need to modify the rule. All comments submitted will be

available, both before and after the closing date for comments, in the

Rules Docket for examination by interested persons. A report that

summarizes each FAA-public contact concerned with the substance of this

AD will be filed in the Rules Docket.

Commenters wishing the FAA to acknowledge receipt of their comments

submitted in response to this rule must submit a self-addressed,

stamped postcard on which the following statement is made: ``Comments

to Docket Number 94-NM-227-AD.'' The postcard will be date stamped and

returned to the commenter.

The regulations adopted herein will not have substantial direct

effects on the States, on the relationship between the national

government and the States, or on the distribution of power and

responsibilities among the various levels of government. Therefore, in

accordance with Executive Order 12612, it is determined that this final

rule does not have sufficient federalism implications to warrant the

preparation of a Federalism Assessment.

The FAA has determined that this regulation is an emergency

regulation that must be issued immediately to correct an unsafe

condition in aircraft, and that it is not a ``significant regulatory

action'' under Executive Order 12866. It has been determined further

that this action involves an emergency regulation under DOT Regulatory

Policies and Procedures (44 FR 11034, February 26, 1979). If it is

determined that this emergency regulation otherwise would be

significant under DOT Regulatory Policies and Procedures, a final

regulatory evaluation will be prepared and placed in the Rules Docket.

A copy of it, if filed, may be obtained from the Rules Docket at the

location provided under the caption ADDRESSES.

List of Subjects in 14 CFR Part 39

Air transportation, Aircraft, Aviation safety, Incorporation by

reference, Safety.

Adoption of the Amendment

Accordingly, pursuant to the authority delegated to me by the

Administrator, the Federal Aviation Administration amends

part 39 of the Federal Aviation Regulations (14 CFR part 39) as

follows:

PART 39--AIRWORTHINESS DIRECTIVES

1. The authority citation for part 39 continues to read as follows:

Authority: 49 U.S.C. App. 1354(a), 1421 and 1423; 49 U.S.C.

106(g); and 14 CFR 11.89.

Sec. 39.13 [Amended]

2. Section 39.13 is amended by adding the following new

airworthiness directive:

95-01-03 Dassault Aviation: Amendment 39-9114. Docket 94-NM-227-AD.

Applicability: Model Mystere-Falcon 50 series airplanes having

serial numbers 2 through 232 inclusive, certificated in any

category.

Note 1: This AD applies to each airplane identified in the

preceding applicability provision, regardless of whether it has been

modified, altered, or repaired in the area subject to the

requirements of this AD. For airplanes that have been modified,

altered, or repaired so that the performance of the requirements of

this AD is affected, the owner/operator must use the authority

provided in paragraph (b) to request approval from the FAA. This

approval may address either no action, if the current configuration

eliminates the unsafe condition; or different actions necessary to

address the unsafe condition described in this AD. Such a request

should include an assessment of the effect of the changed

configuration on the unsafe condition addressed by this AD. In no

case does the presence of any modification, alteration, or repair

remove any airplane from the applicability of this AD.

Compliance: Required as indicated, unless accomplished

previously.

To prevent an electrical fire due to damage of the electrical

wire bundles, accomplish the following:

(a) Within 20 days after the effective date of this AD, measure

the clearance between the electrical bundles in the left-hand

cabinet and the counterbalancing actuator of the passenger door, in

accordance with Dassault Aviation Alert Service Bulletin F50-A243

(F50-A39-1), Revision 1, dated November 10, 1994.

(1) If the clearances are within the limits specified in the

alert service bulletin, no further action is required by this AD.

(2) If the clearances are outside the limits specified in the

alert service bulletin, prior to further flight, reroute and clamp

the wire bundles in accordance with the alert service bulletin.

(b) An alternative method of compliance or adjustment of the

compliance time that provides an acceptable level of safety may be

used if approved by the Manager, Standardization Branch, ANM-113,

FAA, Transport Airplane Directorate. Operators shall submit their

requests through an appropriate FAA Principal Maintenance Inspector,

who may add comments and then send it to the Manager,

Standardization Branch, ANM-113.

Note 2: Information concerning the existence of approved

alternative methods of compliance with this AD, if any, may be

obtained from the Standardization Branch, ANM-113.

(c) Special flight permits may be issued in accordance with

sections 21.197 and 21.199 of the Federal Aviation Regulations (14

CFR 21.197 and 21.199) to operate the airplane to a location where

the requirements of this AD can be accomplished.

(d) The measuring, rerouting, and clamping shall be done in

accordance with Dassault Aviation Alert Service Bulletin F50-A243

(F50-A39-1), Revision 1, dated November 10, 1994. This incorporation

by reference was approved by the Director of the Federal Register in

accordance with 5 U.S.C. 552(a) and 1 CFR part 51. Copies may be

obtained from Falcon Jet Corporation, P.O. Box 967, Little Rock,

Arkansas 72203-0967. Copies may be inspected at the FAA, Transport

Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington; or

at the Office of the Federal Register, 800 North Capitol Street,

NW., suite 700, Washington, DC.

(e) This amendment becomes effective on January 18, 1995.

Issued in Renton, Washington, on December 22, 1994.

Darrell M. Pederson,

Acting Manager, Transport Airplane Directorate, Aircraft Certification

Service.

[FR Doc. 94-32036 Filed 12-30-94; 8:45 am]

BILLING CODE 4910-13-U

This is a copy of a public record, reproduced as it was published. It is not legal advice, and it may not be the version a court would rely on. Check the official source before you cite it.

A word about cookies

We need a few to keep you signed in and the library working. The rest help us see which pages people use and where they get stuck. They stay off unless you say yes.

Airworthiness Directives; Dassault Aviation Model Mystere-Falcon 50 Series Airplanes · 60 FR 3 | Frix