Airworthiness Directives; Agusta S.p.A. Model A109A and A109A II Helicopters

FederalRegulations

Ask Donna

How this section applies to your facts.

Federal Register › Vol. 65 › 65 FR 346

This text was captured on Sep 30, 2026. It is a snapshot, not a live feed, so check the official code before relying on it.

Text

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 39

[Docket No. 99-SW-91-AD; Amendment 39-11493; AD 99-27-12]

RIN 2120-AA64

Airworthiness Directives; Agusta S.p.A. Model A109A and A109A II

Helicopters

AGENCY: Federal Aviation Administration, DOT.

ACTION: Final rule; request for comments.

-----------------------------------------------------------------------

SUMMARY: This amendment supersedes an existing airworthiness directive

(AD), applicable to Agusta Model A109A and A109A II helicopters, that

currently requires, before further flight, inspecting any tail rotor

blade (blade) with 400 or more hours time-in-service (TIS) for a crack

and replacing any cracked blade before further flight. This amendment

contains the same requirements as the current AD but corrects the

paragraph that requires ``replacing any cracked blade with an

unairworthy blade.'' This amendment is prompted by the need to correct

the requirement to mandate

``replacing any cracked blade with an airworthy blade.'' The actions

specified by this AD are intended to prevent fatigue failure of the

blade, loss of the tail rotor, and subsequent loss of control of the

helicopter.

DATES: Effective January 5, 2000. The incorporation by reference of

certain publications listed in the regulations was approved previously

by the Director of the Federal Register as of January 4, 2000.

Comments for inclusion in the Rules Docket must be received on or

before March 6, 2000.

ADDRESSES: Submit comments in triplicate to the Federal Aviation

Administration (FAA), Office of the Regional Counsel, Southwest Region,

Attention: Rules Docket No. 99-SW-91-AD, 2601 Meacham Blvd., Room 663,

Fort Worth, Texas 76137.

The service information referenced in this AD may be obtained from

Agusta, 21017 Cascina Costa di Samarate (VA), Via Giovanni Agusta 520,

telephone (0331) 229111, fax (0331) 229605-222595. This information may

be examined at the FAA, Office of the Regional Counsel, Southwest

Region, 2601 Meacham Blvd., Room 663, Fort Worth, Texas 76137; or at

the Office of the Federal Register, 800 North Capitol Street, NW.,

suite 700, Washington, DC.

FOR FURTHER INFORMATION CONTACT: Richard A. Monschke, Aerospace

Engineer, FAA, Rotorcraft Directorate, Rotorcraft Standards Staff, 2601

Meacham Blvd., Fort Worth, Texas 76137, telephone (817) 222-5116, fax

(817) 222-5961.

SUPPLEMENTARY INFORMATION: On December 9, 1999, the FAA issued AD 99-

26-13, Amendment 39-11472, Docket No. 99-SW-64-AD, effective January 4,

2000, to require inspecting any tail rotor blade, part number (P/N)

109-0132-02 (all dash numbers), with 400 or more hours TIS for a crack

and replacing any cracked blade with an airworthy blade. That action

was prompted by three reports of cracked blades and two reports of

separation of a tail rotor gearbox. That condition, if not corrected,

could result in fatigue failure of a blade, loss of the tail rotor, and

subsequent loss of control of the helicopter.

Agusta S.p.A. issued Bollettino Tecnico 109-110, dated July 28,

1999 (technical bulletin), which supersedes Telegraphic Technical

Bulletin 109-5, dated January 27, 1987. The technical bulletin

specifies dye-penetrant inspecting any blade, P/N 109-0132-02 (all dash

numbers), with 400 or more hours TIS, for a crack before further flight

and thereafter at intervals not to exceed 100 hours TIS. The technical

bulletin also specifies visually inspecting each blade before the first

flight of each day and replacing any cracked blade. In the technical

bulletin, the manufacturer reemphasizes the importance of performing a

detailed inspection of the blade by publishing additional procedures

and requirements for personnel conducting the inspections. Agusta

S.p.A. is attempting to develop an improved blade, which would provide

a basis for terminating the inspection requirement.

Since the issuance of that AD, the FAA has discovered that the

requirement in paragraph (b) of AD-99-26-13 mandates replacing a

cracked blade with an unairworthy blade. This was an error. The

requirement should mandate that any cracked blade be replaced with an

airworthy blade.

Since an unsafe condition has been identified that is likely to

exist or develop on other Agusta Model A109A and A109A II helicopters

of the same type design, this AD supersedes AD 99-26-13, effective

January 4, 2000. This AD corrects the mistake in AD 99-26-13 and

requires that any cracked blade be replaced with an airworthy blade.

This AD also requires dye-penetrant inspecting any blade, P/N 109-0132-

02 (all dash numbers), with 400 or more hours TIS, for a crack before

further flight and thereafter at intervals not to exceed 100 hours TIS.

Also, this AD requires visually inspecting each blade before the first

flight of each day. The actions are required to be accomplished in

accordance with the technical bulletin described previously. The short

compliance time involved is required because the previously described

critical unsafe condition can adversely affect the controllability and

structural integrity of the helicopter. Therefore, dye-penetrant

inspecting each blade for a crack is required before further flight and

this AD must be issued immediately.

Since a situation exists that requires the immediate adoption of

this regulation, it is found that notice and opportunity for prior

public comment hereon are impracticable, and that good cause exists for

making this amendment effective in less than 30 days.

The FAA estimates that 54 helicopters will be affected by this AD,

that it will take approximately 2.5 work hours to accomplish the

inspections, and that the average labor rate is $60 per work hour.

Based on these figures, the total cost impact of the AD on U.S.

operators is estimated to be $48,600 assuming 6 dye penetrant

inspections a year.

Comments Invited

Although this action is in the form of a final rule that involves

requirements affecting flight safety and, thus, was not preceded by

notice and an opportunity for public comment, comments are invited on

this rule. Interested persons are invited to comment on this rule by

submitting such written data, views, or arguments as they may desire.

Communications should identify the Rules Docket number and be submitted

in triplicate to the address specified under the caption ADDRESSES. All

communications received on or before the closing date for comments will

be considered, and this rule may be amended in light of the comments

received. Factual information that supports the commenter's ideas and

suggestions is extremely helpful in evaluating the effectiveness of the

AD action and determining whether additional rulemaking action would be

needed.

Comments are specifically invited on the overall regulatory,

economic, environmental, and energy aspects of the rule that might

suggest a need to modify the rule. All comments submitted will be

available, both before and after the closing date for comments, in the

Rules Docket for examination by interested persons. A report that

summarizes each FAA-public contact concerned with the substance of this

AD will be filed in the Rules Docket.

Commenters wishing the FAA to acknowledge receipt of their comments

submitted in response to this rule must submit a self-addressed,

stamped postcard on which the following statement is made: ``Comments

to Docket No. 99-SW-91-AD.'' The postcard will be date stamped and

returned to the commenter.

The regulations adopted herein will not have a substantial direct

effect on the States, on the relationship between the national

Government and the States, or on the distribution of power and

responsibilities among the various levels of government. Therefore, it

is determined that this final rule does not have federalism

implications under Executive Order 13132.

The FAA has determined that this regulation is an emergency

regulation that must be issued immediately to correct an unsafe

condition in aircraft, and that it is not a ``significant regulatory

action'' under Executive Order 12866. It has been determined further

that this action involves an emergency regulation under DOT Regulatory

Policies and Procedures (44 FR 11034, February 26, 1979). If it is

determined that this emergency

regulation otherwise would be significant under DOT Regulatory Policies

and Procedures, a final regulatory evaluation will be prepared and

placed in the Rules Docket. A copy of it, if filed, may be obtained

from the Rules Docket at the location provided under the caption

ADDRESSES.

List of Subjects in 14 CFR Part 39

Air transportation, Aircraft, Aviation safety, Incorporation by

reference, Safety.

Adoption of the Amendment

Accordingly, pursuant to the authority delegated to me by the

Administrator, the Federal Aviation Administration amends part 39 of

the Federal Aviation Regulations (14 CFR part 39) as follows:

PART 39--AIRWORTHINESS DIRECTIVES

1. The authority citation for part 39 continues to read as follows:

Authority: 49 U.S.C. 106(g), 40113, 44701.

Sec. 39.13 [Amended]

2. Section 39.13 is amended by removing Amendment 39-11472 and by

adding a new airworthiness directive (AD), Amendment 39-11493, to read

as follows:

AD 99-27-12 Agusta S.p.A.: Amendment 39-11493. Docket No.99-SW-91-

AD. Supersedes AD 99-26-13, Amendment 39-11472, Docket No. 99-SW-64-

AD.

Applicability: Model A109A and A109A II helicopters, with tail

rotor blade (blade), part number (P/N) 109-0132-02-all dash numbers,

with 400 or more hours time-in-service (TIS), installed,

certificated in any category.

Note 1: This AD applies to each helicopter identified in the

preceding applicability provision, regardless of whether it has been

otherwise modified, altered, or repaired in the area subject to the

requirements of this AD. For helicopters that have been modified,

altered, or repaired so that the performance of the requirements of

this AD is affected, the owner/operator must request approval for an

alternative method of compliance in accordance with paragraph (c) of

this AD. The request should include an assessment of the effect of

the modification, alteration, or repair on the unsafe condition

addressed by this AD; and, if the unsafe condition has not been

eliminated, the request should include specific proposed actions to

address it.

Compliance: Required as indicated, unless accomplished

previously.

To prevent fatigue failure of a blade, loss of the tail rotor,

and subsequent loss of control of the helicopter, accomplish the

following:

(a) Before further flight, dye-penetrant inspect each blade for

a crack in accordance with the Compliance Instructions, Part I, of

Agusta S.p.A. Bollettino Tecnico 109-110, dated July 28, 1999

(technical bulletin). Thereafter, at intervals not to exceed 100

hours TIS, dye-penetrant inspect each blade for a crack in

accordance with the Compliance Instructions, Part III, of the

technical bulletin. If a crack is found, replace the cracked blade

with an airworthy blade before further flight.

(b) Before the first flight each day, visually inspect each

blade for a crack using a 3 to 5 power magnifying glass in

accordance with the Compliance Instructions, Part II, of the

technical bulletin. If a crack is found, replace the cracked blade

with an airworthy blade before further flight.

(c) An alternative method of compliance or adjustment of the

compliance time that provides an acceptable level of safety may be

used if approved by the Manager, Regulations Group, FAA, Rotorcraft

Directorate. Operators shall submit their requests through an FAA

Principal Maintenance Inspector, who may concur or comment and then

send it to the Manager, Regulations Group.

Note 2: Information concerning the existence of approved

alternative methods of compliance with this AD, if any, may be

obtained from the Regulations Group.

(d) Special flight permits will not be issued.

(e) The inspections shall be done in accordance with the

Compliance Instructions of Agusta S.p.A. Bollettino Tecnico 109-110,

dated July 28, 1999. The incorporation by reference of that document

was approved previously by the Director of the Federal Register in

accordance with 5 U.S.C. 552(a) and 1 CFR part 51 as of January 4,

2000. Copies may be obtained from Agusta, 21017 Cascina Costa di

Samarate (VA), Via Giovanni Agusta 520, telephone (0331) 229111, fax

(0331) 229605-222595. Copies may be inspected at the FAA, Office of

the Regional Counsel, Southwest Region, 2601 Meacham Blvd., Room

663, Fort Worth, Texas; or at the Office of the Federal Register,

800 North Capitol Street, NW., suite 700, Washington, DC.

(f) This amendment becomes effective on January 5, 2000.

Note 3: The subject of this AD is addressed in Registro

Aeronautico Italiano, Italy, AD 99-325, dated August 2, 1999.

Issued in Fort Worth, Texas, on December 27, 1999.

Larry M. Kelly,

Acting Manager, Rotorcraft Directorate Aircraft Certification Service.

[FR Doc. 00-17 Filed 1-4-00; 8:45 am]

BILLING CODE 4910-13-U

This is a copy of a public record, reproduced as it was published. It is not legal advice, and it may not be the version a court would rely on. Check the official source before you cite it.

A word about cookies

We need a few to keep you signed in and the library working. The rest help us see which pages people use and where they get stuck. They stay off unless you say yes.

Airworthiness Directives; Agusta S.p.A. Model A109A and A109A II Helicopters · 65 FR 346 | Frix