§ 36.13 Acoustical change: Tiltrotor aircraft.
FederalRegulations
Ask Donna
How this section applies to your facts.
Title 14 CFR: Aeronautics and Space › Chapter I: FEDERAL AVIATION ADMINISTRATION, DEPARTMENT OF TRANSPORTATION › Part 36: NOISE STANDARDS: AIRCRAFT TYPE AND AIRWORTHINESS CERTIFICATION › Subpart A: General › § 36.13: § 36.13 Acoustical change: Tiltrotor aircraft.
Text
The following requirements apply to tiltrotors in any category for which an acoustical change approval is applied for under § 21.93(b) of this chapter on or after March 11, 2013:
(a) In showing compliance with Appendix K of this part, noise levels must be measured, evaluated, and calculated in accordance with the applicable procedures and conditions prescribed in Appendix K of this part.
(b) Compliance with the noise limits prescribed in section K4 (Noise Limits) of Appendix K of this part must be shown in accordance with the applicable provisions of sections K2 (Noise Evaluation Measure), K3 (Noise Measurement Reference Points), K6 (Noise Certification Reference Procedures), and K7 (Test Procedures) of Appendix K of this part.
(c) After a change in type design, tiltrotor noise levels may not exceed the limits specified in § 36.1103.
[Amdt. 36-29, 78 FR 1139, Jan. 8, 2013]
This is a copy of a public record, reproduced as it was published. It is not legal advice, and it may not be the version a court would rely on. Check the official source before you cite it.