7 DE Admin. Code 1.0. Overview
DelawareRegulations
Ask Donna
How this section applies to your facts.
Delaware Administrative Code › Title 7 Natural Resources and Environmental Control › 1100 Division of Air Quality › 1138 Emission Standards for Hazardous Air Pollutants for Source Categories › 7 DE Admin. Code 1.0
Text
Section | Title | Related federal rule at 40 CFR Part 63
Table of Contents
1.0 | Overview
2.0 | Reserved
3.0 | General Provisions | Subpart A
4.0 | Requirements for Case-By-Case Control Technology Determinations for Major Sources | Subpart B
5.0 | Perchloroethylene Air Emission Standards for Dry Cleaning Facilities | Subpart M
6.0 | Emission Standards for Chromium Emissions From Hard and Decorative Chromium Electroplating and Chromium Anodizing Tanks | Subpart N
7.0 | Emission Standards for Hazardous Air Pollutants for Industrial Process Cooling Towers | Subpart Q
8.0 | Emission Standards for Halogenated Solvent Cleaning | Subpart T
9.0 | Emission Standards for Hospital Ethylene Oxide Sterilizers | Subpart WWWWW
10.0 | Emission Standards for Hazardous Air Pollutants for Area Source Plating and Polishing Operations | Subpart WWWWWW
11.0 | Emission Standards for Hazardous Air Pollutants for Area Source Lead Acid Battery Manufacturing Plants | Subpart PPPPPP
12.0 | Emission Standards for Hazardous Air Pollutants for Secondary Aluminum Production | Subpart RRR
13.0 | Emission Standards for Hazardous Air Pollutants for Area Source Paint Stripping Operations | Subpart HHHHHH
14.0 | Emission Standards for Hazardous Air Pollutants for Area Source Miscellaneous Parts or Products Surface Coating Operations | Subpart HHHHHH
15.0 | Emission Standards for Hazardous Air Pollutants for Area Source Motor Vehicle or Mobile Equipment Surface Coating Operations | Subpart HHHHHH
16.0 | Emission Standards for Hazardous Air Pollutants for Area Source Asphalt Processing and Asphalt Roofing Products Manufacturing Operations | Subpart AAAAAAA
17.0 | Emission Standards for Hazardous Air Pollutants for Area Source Prepared Feeds Manufacturing Facilities | Subpart DDDDDDD
Title 7 Natural Resources and Environmental Control
1138 Emission Standards for Hazardous Air Pollutants for Source Categories
DEPARTMENT OF NATURAL RESOURCES AND ENVIRONMENTAL CONTROL
Division of Air Quality
1138 Emission Standards for Hazardous Air Pollutants for Source
.0 | Emission Standards for Hazardous Air Pollutants for Area Source Prepared Feeds Manufacturing Facilities | Subpart DDDDDDD
Title 7 Natural Resources and Environmental Control
1138 Emission Standards for Hazardous Air Pollutants for Source Categories
DEPARTMENT OF NATURAL RESOURCES AND ENVIRONMENTAL CONTROL
Division of Air Quality
1138 Emission Standards for Hazardous Air Pollutants for Source Categories
04/04/1998
1.0 Overview
Title III of the Clean Air Act Amendments of November 15, 1990 revised Section 112 of the 1970 Clean Air Act that addressed hazardous air pollutants (HAPs) and changed the way that these pollutants were to be regulated. Title III identified the specific HAPs and established the regulatory approach that the U.S. Environmental Protection Agency (EPA) would take to control their emissions from stationary sources.
The EPA is initially required to promulgate emission standards that are based on the maximum achievable control technology (MACT) for categories or subcategories of sources according to a Congress-mandated schedule. Within eight years of promulgating these MACT-based standards, the EPA is required to address the remaining or residual risk by promulgating, if needed, standards necessary to provide an ample margin of safety to protect public health or to prevent an adverse environmental effect. The initial MACT-based regulations are at 40 CFR Part 63.
The Department is adopting these regulations in response to 7 Del.C., Ch 60 .
09/11/1999
This is a copy of a public record, reproduced as it was published. It is not legal advice, and it may not be the version a court would rely on. Check the official source before you cite it.