Airworthiness Directives; Fokker Model F.28 Mark 0070 and 0100 Series Airplanes

FederalRegulations

Ask Donna

How this section applies to your facts.

Federal Register › Vol. 64 › 64 FR 3202

This text was captured on Sep 30, 2026. It is a snapshot, not a live feed, so check the official code before relying on it.

Text

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 39

[Docket No. 98-NM-276-AD; Amendment 39-11004; AD 99-02-12]

RIN 2120-AA64

Airworthiness Directives; Fokker Model F.28 Mark 0070 and 0100

Series Airplanes

AGENCY: Federal Aviation Administration, DOT.

ACTION: Final rule.

-----------------------------------------------------------------------

SUMMARY: This amendment adopts a new airworthiness directive (AD),

applicable to certain Fokker Model F.28 Mark 0070 and 0100 series

airplanes, that requires a one-time visual inspection to detect

discrepancies of the components of the torque link apex joint and

shimmy damper attachments of the main landing gear (MLG), and repair or

replacement of any discrepant component with a new or serviceable

component. This amendment is prompted by issuance of mandatory

continuing airworthiness information by a foreign civil airworthiness

authority. The actions specified by this AD are intended to prevent

heavy vibration and possible damage to the components of the MLG, and

consequent reduced controllability of the airplane during takeoff and

landing.

DATES: Effective February 25, 1999.

The incorporation by reference of certain publications listed in

the regulations is approved by the Director of the Federal Register as

of February 25, 1999.

ADDRESSES: The service information referenced in this AD may be

obtained from Fokker Services B.V., Technical Support Department, P.O.

Box 75047, 1117 ZN Schiphol Airport, the Netherlands. This information

may be examined at the Federal Aviation Administration (FAA), Transport

Airplane Directorate, Rules Docket, 1601 Lind Avenue, SW., Renton,

Washington; or at the Office of the Federal Register, 800 North Capitol

Street, NW., suite 700, Washington, DC.

FOR FURTHER INFORMATION CONTACT: Norman B. Martenson, Manager,

International Branch, ANM-116, FAA, Transport Airplane Directorate,

1601 Lind Avenue, SW., Renton, Washington 98055-4056; telephone (425)

227-2110; fax (425) 227-1149.

SUPPLEMENTARY INFORMATION: A proposal to amend part 39 of the Federal

Aviation Regulations (14 CFR part 39) to include an airworthiness

directive (AD) that is applicable to certain Fokker Model F.28 Mark

0070 and 0100 series airplanes was published in the Federal Register on

November 13, 1998 (63 FR 63423). That action proposed to require a one-

time visual inspection to detect discrepancies of the components of the

torque link apex joint and shimmy damper attachments of the main

landing gear (MLG), and repair or replacement of any discrepant

component with a new or serviceable component.

Interested persons have been afforded an opportunity to participate

in the making of this amendment. Due consideration has been given to

the comments received.

Two commenters state that they are not affected by the proposed

rule and, therefore, have no technical comments regarding the proposed

rule.

Conclusion

After careful review of the available data, including the comments

noted above, the FAA has determined that air safety and the public

interest require the adoption of the rule as proposed.

Cost Impact

The FAA estimates that 131 Model F.28 Mark 0070 and 0100 series

airplanes of U.S. registry will be affected by this AD, that it will

take approximately 2 work hours per airplane to accomplish the required

inspection, and that the average labor rate is $60 per work hour. Based

on these figures, the cost impact of the AD on U.S. operators is

estimated to be $15,720, or $120 per airplane.

The cost impact figure discussed above is based on assumptions that

no operator has yet accomplished any of the requirements of this AD

action, and that no operator would accomplish those actions in the

future if this AD were not adopted.

Regulatory Impact

The regulations adopted herein will not have substantial direct

effects on the States, on the relationship between the national

government and the States, or on the distribution of power and

responsibilities among the various levels of government. Therefore, in

accordance with Executive Order 12612, it is determined that this final

rule does not have sufficient federalism implications to warrant the

preparation of a Federalism Assessment.

For the reasons discussed above, I certify that this action (1) is

not a ``significant regulatory action'' under Executive Order 12866;

(2) is not a ``significant rule'' under DOT Regulatory Policies and

Procedures (44 FR 11034, February 26, 1979); and (3) will not have a

significant economic impact, positive or negative, on a substantial

number of small entities under the criteria of the Regulatory

Flexibility Act. A final evaluation has been prepared for this action

and it is contained in the Rules Docket. A copy of it may be obtained

from the Rules Docket at the location provided under the caption

ADDRESSES.

List of Subjects in 14 CFR Part 39

Air transportation, Aircraft, Aviation safety, Incorporation by

reference, Safety.

Adoption of the Amendment

Accordingly, pursuant to the authority delegated to me by the

Administrator, the Federal Aviation Administration amends part 39 of

the Federal Aviation Regulations (14 CFR part 39) as follows:

PART 39--AIRWORTHINESS DIRECTIVES

1. The authority citation for part 39 continues to read as follows:

Authority: 49 U.S.C. 106(g), 40113, 44701.

Sec. 39.13 [Amended]

2. Section 39.13 is amended by adding the following new

airworthiness directive:

99-02-12 Fokker Services B.V.: Amendment 39-11004. Docket 98-NM-

276-AD.

Applicability: Model F.28 Mark 0070 and 0100 series airplanes,

as listed in Fokker Service Bulletin SBF100-32-113, dated May 28,

1998; certificated in any category.

Note 1: This AD applies to each airplane identified in the

preceding applicability provision, regardless of whether it has been

modified, altered, or repaired in the area subject to the

requirements of this AD. For airplanes that have been modified,

altered, or repaired so that the performance of the requirements of

this AD is affected, the owner/operator must request approval for an

alternative method of compliance in accordance with paragraph (d) of

this AD. The request should include an assessment of the effect of

the modification, alteration, or repair on the unsafe condition

addressed by this AD; and, if the unsafe condition has not been

eliminated, the request should include specific proposed actions to

address it.

Compliance: Required as indicated, unless accomplished

previously.

To prevent heavy vibration and possible damage to the components

of the main landing gear (MLG), and consequent reduced

controllability of the airplane during takeoff or landing,

accomplish the following:

(a) Within 45 days after the effective date of this AD, perform

a one-time visual inspection to detect discrepancies of the

components of the torque link apex joint and shimmy damper

attachments of the MLG, in accordance with Fokker Service Bulletin

SBF100-32-113, dated May 28, 1998. If any discrepancy is detected,

prior to further flight, repair or replace any discrepant component

with a new or serviceable component, in accordance with the service

bulletin.

Note 2: In paragraph 2.F.(10) of the Accomplishment Instructions

of Fokker Service Bulletin SBF100-32-113, dated May 28, 1998, the

parenthetical phrase that recommends the size of torque wrench to

use, should read ``* * * (0 to 75 lbf ft),'' rather than ``* * * (0

to 75 lbf in)''.

(b) Submit a report of the inspection findings (positive or

negative) to Fokker Services B.V., Technical Services, Attn.:

Manager Airline Support, P.O. Box 75047, 1117 ZN Schiphol-Oost, the

Netherlands; Fax No. 3120605200; at the time specified in paragraph

(b)(1) or (b)(2) of this AD, as applicable. Information collection

requirements contained in this regulation have been approved by the

Office of Management and Budget (OMB) under the provisions of the

Paperwork Reduction Act of 1980 (44 U.S.C. 3501 et seq.) and have

been assigned OMB Control Number 2120-0056.

(1) For airplanes on which the inspection required by paragraph

(a) of this AD is accomplished after the effective date of this AD:

Submit a report within 10 days after accomplishing the inspection

required by paragraph (a) of this AD.

(2) For airplanes on which the inspection required by paragraph

(a) of this AD has been accomplished prior to the effective date of

this AD: Submit a report within 30 days after the effective date of

this AD.

(c) As of the effective date of this AD, no person shall install

on any airplane a Menasco MLG having part number (P/N) 41050-5, -6,

-7, or -8; or P/N 41060-1 or -2; unless it has been inspected in

accordance with paragraph (a) of this AD.

(d) An alternative method of compliance or adjustment of the

compliance time that provides an acceptable level of safety may be

used if approved by the Manager, International Branch, ANM-116, FAA,

Transport Airplane Directorate. Operators shall submit their

requests through an appropriate FAA Principal Maintenance Inspector,

who may add comments and then send it to the Manager, International

Branch, ANM-116.

Note 3: Information concerning the existence of approved

alternative methods of compliance with this AD, if any, may be

obtained from the International Branch, ANM-116.

(e) Special flight permits may be issued in accordance with

sections 21.197 and 21.199 of the Federal Aviation Regulations (14

CFR 21.197 and 21.199) to operate the airplane to a location where

the requirements of this AD can be accomplished.

(f) Except as provided by paragraph (b) of this AD, the actions

shall be done in accordance with Fokker Service Bulletin SBF100-32-

113, dated May 28, 1998. This incorporation by reference was

approved by the Director of the Federal Register in accordance with

5 U.S.C. 552(a) and 1 CFR part 51. Copies may be obtained from

Fokker Services B.V., Technical Support Department, P.O. Box 75047,

1117 ZN Schiphol Airport, the Netherlands. Copies may be inspected

at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW.,

Renton, Washington; or at the Office of the Federal Register, 800

North Capitol Street, NW., suite 700, Washington, DC.

Note 4: The subject of this AD is addressed in Dutch

airworthiness directive BLA 1998-058 (A), dated May 29, 1998.

(g) This amendment becomes effective on February 25, 1999.

Issued in Renton, Washington, on January 12, 1999.

Darrell M. Pederson,

Acting Manager,

Transport Airplane Directorate, Aircraft Certification Service.

[FR Doc. 99-1184 Filed 1-20-99; 8:45 am]

BILLING CODE 4910-13-P

This is a copy of a public record, reproduced as it was published. It is not legal advice, and it may not be the version a court would rely on. Check the official source before you cite it.

A word about cookies

We need a few to keep you signed in and the library working. The rest help us see which pages people use and where they get stuck. They stay off unless you say yes.