Airworthiness Directives; British Aerospace Model BAe 146 and Avro 146-RJ Series Airplanes

FederalRegulations

Ask Donna

How this section applies to your facts.

Federal Register › Vol. 62 › 62 FR 1275

This text was captured on Sep 30, 2026. It is a snapshot, not a live feed, so check the official code before relying on it.

Text

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 39

[Docket No. 96-NM-51-AD; Amendment 39-9878; AD 97-01-07]

RIN 2120-AA64

Airworthiness Directives; British Aerospace Model BAe 146 and

Avro 146-RJ Series Airplanes

AGENCY: Federal Aviation Administration, DOT.

ACTION: Final rule.

-----------------------------------------------------------------------

SUMMARY: This amendment adopts a new airworthiness directive (AD),

applicable to all British Aerospace Model BAe 146 and Avro 146-RJ

series airplanes, that requires modification of the left and right

elevators, and replacement of the elevator spring with a stiffer

spring. This amendment is prompted by reports indicating that water and

ice have accumulated at the trailing edge of the left and right

elevators; this accumulation can cause

the elevators to become unbalanced, and oscillate or flutter. The

actions specified by this AD are intended to prevent this oscillation

or flutter. Elevator oscillation, if not corrected, could result in

reduced controllability of the airplane. Elevator flutter, if not

corrected, could couple with the natural vibrations of the airplane,

and result in loss of the airplane's structural integrity.

DATES: Effective February 13, 1997.

The incorporation by reference of certain publications listed in

the regulations is approved by the Director of the Federal Register as

of February 13, 1997.

ADDRESSES: The service information referenced in this AD may be

obtained from British Aerospace Regional Aircraft Limited, Avro

International Aerospace Division, Customer Support, Woodford Aerodrome,

Woodford, Cheshire SK7 1QR, England. This information may be examined

at the Federal Aviation Administration (FAA), Transport Airplane

Directorate, Rules Docket, 1601 Lind Avenue, SW., Renton, Washington;

or at the Office of the Federal Register, 800 North Capitol Street,

NW., suite 700, Washington, DC.

FOR FURTHER INFORMATION CONTACT: Tim Backman, Aerospace Engineer,

Standardization Branch, ANM-113, FAA, Transport Airplane Directorate,

1601 Lind Avenue, SW., Renton, Washington 98055-4056; telephone (206)

227-2797; fax (206) 227-1149.

SUPPLEMENTARY INFORMATION: A proposal to amend part 39 of the Federal

Aviation Regulations (14 CFR part 39) to include an airworthiness

directive (AD) that is applicable to all British Aerospace Model BAe

146 and Avro 146-RJ series airplanes was published in the Federal

Register on October 18, 1996 (61 FR 54362). That action proposed to

require modification of the left and right elevators by installation of

mass balance weights at the leading edge of the horn, forward of the

hinge line; and replacement of the elevator spring with a stiffer

spring.

Interested persons have been afforded an opportunity to participate

in the making of this amendment. No comments were submitted in response

to the proposal or the FAA's determination of the cost to the public.

Conclusion

The FAA has determined that air safety and the public interest

require the adoption of the rule as proposed.

Cost Impact

The FAA estimates that 52 British Aerospace Model BAe 146 and Avro

146-RJ series airplanes of U.S. registry will be affected by this AD,

that it will take approximately 12 work hours per airplane to

accomplish the required actions, and that the average labor rate is $60

per work hour. Required parts will cost approximately $700 per

airplane. Based on these figures, the cost impact of the AD on U.S.

operators is estimated to be $73,840, or $1,420 per airplane.

The cost impact figure discussed above is based on assumptions that

no operator has yet accomplished any of the requirements of this AD

action, and that no operator would accomplish those actions in the

future if this AD were not adopted.

Regulatory Impact

The regulations adopted herein will not have substantial direct

effects on the States, on the relationship between the national

government and the States, or on the distribution of power and

responsibilities among the various levels of government. Therefore, in

accordance with Executive Order 12612, it is determined that this final

rule does not have sufficient federalism implications to warrant the

preparation of a Federalism Assessment.

For the reasons discussed above, I certify that this action (1) is

not a ``significant regulatory action'' under Executive Order 12866;

(2) is not a ``significant rule'' under DOT Regulatory Policies and

Procedures (44 FR 11034, February 26, 1979); and (3) will not have a

significant economic impact, positive or negative, on a substantial

number of small entities under the criteria of the Regulatory

Flexibility Act. A final evaluation has been prepared for this action

and it is contained in the Rules Docket. A copy of it may be obtained

from the Rules Docket at the location provided under the caption

ADDRESSES.

List of Subjects in 14 CFR Part 39

Air transportation, Aircraft, Aviation safety, Incorporation by

reference, Safety.

Adoption of the Amendment

Accordingly, pursuant to the authority delegated to me by the

Administrator, the Federal Aviation Administration amends part 39 of

the Federal Aviation Regulations (14 CFR part 39) as follows:

PART 39--AIRWORTHINESS DIRECTIVES

1. The authority citation for part 39 continues to read as follows:

Authority: 49 U.S.C. 106(g), 40113, 44701.

Sec. 39.13--[Amended]

2. Section 39.13 is amended by adding the following new

airworthiness directive:

97-01-07 British Aerospace Regional Aircraft Limited, AVRO

International Aerospace Division (Formerly British Aerospace, plc;

British Aerospace Commercial Aircraft Limited): Amendment 39-9878.

Docket 96-NM-51-AD.

Applicability: All Model BAe 146 and Avro 146-RJ series

airplanes, certificated in any category.

Note 1: This AD applies to each airplane identified in the

preceding applicability provision, regardless of whether it has been

otherwise modified, altered, or repaired in the area subject to the

requirements of this AD. For airplanes that have been modified,

altered, or repaired so that the performance of the requirements of

this AD is affected, the owner/operator must request approval for an

alternative method of compliance in accordance with paragraph (c) of

this AD. The request should include an assessment of the effect of

the modification, alteration, or repair on the unsafe condition

addressed by this AD; and, if the unsafe condition has not been

eliminated, the request should include specific proposed actions to

address it.

Compliance: Required as indicated, unless accomplished

previously.

To prevent the left and right elevators from oscillating or

fluttering, which could result in either reduced controllability of the

airplane, or loss of the airplane's structural integrity, accomplish

the following:

(a) Within 12 months after the effective date of this AD,

accomplish the requirements of paragraphs (a)(1) and (a)(2) of this

AD.

(1) Modify the left and right elevators by installing mass

balance weights at the leading edge of the horn, forward of the

elevator hinge line, in accordance with British Aerospace Service

Bulletin SB.55-014-01510A, dated December 15, 1995. And

(2) Replace the left and right elevator spring with a stiffer

spring, in accordance with British Aerospace Service Bulletin SB.27-

150-01510B, dated December 15, 1995.

(b) As of 12 months after the effective date of this AD, no

person shall install on any airplane an elevator that has not been

modified in accordance with paragraph (a) of this AD.

(c) An alternative method of compliance or adjustment of the

compliance time that provides an acceptable level of safety may be

used if approved by the Manager, Manager, Standardization Branch,

ANM-113, FAA, Transport Airplane Directorate. Operators shall submit

their requests through an appropriate FAA Principal Maintenance

Inspector, who may add comments and then send it to the Manager,

Standardization Branch, ANM-113.

Note 2: Information concerning the existence of approved

alternative methods of compliance with this AD, if any, may be

obtained from the Standardization Branch, ANM-113.

(d) Special flight permits may be issued in accordance with

sections 21.197 and 21.199

of the Federal Aviation Regulations (14 CFR 21.197 and 21.199) to

operate the airplane to a location where the requirements of this AD

can be accomplished.

(e) The modification and replacement shall be done in accordance

with British Aerospace Service Bulletin SB.55-014-01510A, dated

December 15, 1995; and British Aerospace Service Bulletin SB.27-150-

01510B, dated December 15, 1995. This incorporation by reference was

approved by the Director of the Federal Register in accordance with

5 U.S.C. 552(a) and 1 CFR part 51. Copies may be obtained from

British Aerospace Regional Aircraft Limited, Avro International

Aerospace Division, Customer Support, Woodford Aerodrome, Woodford,

Cheshire SK7 1QR, England. Copies may be inspected at the FAA,

Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton,

Washington; or at the Office of the Federal Register, 800 North

Capitol Street, NW., suite 700, Washington, DC.

(f) This amendment becomes effective on February 13, 1997.

Issued in Renton, Washington, on January 2, 1997.

S. R. Miller,

Acting Manager, Transport Airplane Directorate, Aircraft Certification

Service.

[FR Doc. 97-365 Filed 1-8-97; 8:45 am]

BILLING CODE 4910-13-U

This is a copy of a public record, reproduced as it was published. It is not legal advice, and it may not be the version a court would rely on. Check the official source before you cite it.

A word about cookies

We need a few to keep you signed in and the library working. The rest help us see which pages people use and where they get stuck. They stay off unless you say yes.

Airworthiness Directives; British Aerospace Model BAe 146 and Avro 146-RJ Series Airplanes · 62 FR 1275 | Frix