Airworthiness Directives; Fokker Model F27 Mark 100, 200, 300, 400, 500, 600, and 700 Series Airplanes

FederalRegulations

Ask Donna

How this section applies to your facts.

Federal Register › Vol. 62 › 62 FR 1277

This text was captured on Sep 30, 2026. It is a snapshot, not a live feed, so check the official code before relying on it.

Text

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 39

[Docket No. 96-NM-28-AD; Amendment 39-9879; AD 97-01-08]

RIN: 2120-AA64

Airworthiness Directives; Fokker Model F27 Mark 100, 200, 300,

400, 500, 600, and 700 Series Airplanes

AGENCY: Federal Aviation Administration, DOT.

ACTION: Final rule.

-----------------------------------------------------------------------

SUMMARY: This amendment adopts a new airworthiness directive (AD),

applicable to certain Fokker Model F27 Mark 100, 200, 300, 400, 500,

600, and 700 series airplanes, that requires a one-time visual

inspection to detect missing rivet heads or loose rivets of the

applicable stringer-to-rib connections in the upper and lower wing

skin, and repair, if necessary. In lieu of the one-time visual

inspection or in addition to that inspection, the AD also requires

replacement of certain rivets with certain new rivets in all applicable

rib-to-stringer connections of the upper and lower wings. This

amendment is prompted by reports of missing rivet heads at the rib-to-

stringer connections of the upper and lower wing skin at stringers 5

and 6. The actions specified by this AD are intended to prevent reduced

structural integrity of the wings that is caused by problems associated

with missing and/or loose rivets.

DATES: Effective February 13, 1997.

The incorporation by reference of certain publications listed in

the regulations is approved by the Director of the Federal Register as

of February 13, 1997.

ADDRESSES: The service information referenced in this AD may be

obtained from Fokker Aircraft USA, Inc., 1199 North Fairfax Street,

Alexandria, Virginia 22314. This information may be examined at the

Federal Aviation Administration (FAA), Transport Airplane Directorate,

Rules Docket, 1601 Lind Avenue, SW., Renton, Washington; or at the

Office of the Federal Register, 800 North Capitol Street, NW., suite

700, Washington, DC.

FOR FURTHER INFORMATION CONTACT: Ruth E. Harder, Aerospace Engineer,

Standardization Branch, ANM-113, FAA, Transport Airplane Directorate,

1601 Lind Avenue, SW., Renton, Washington 98055-4056; telephone (206)

227-1721; fax (206) 227-1149.

SUPPLEMENTARY INFORMATION: A proposal to amend part 39 of the Federal

Aviation Regulations (14 CFR part 39) to include an airworthiness

directive (AD) that is applicable to certain Fokker Model F27 Mark 100,

200, 300, 400, 500, 600, and 700 series airplanes was published in the

Federal Register on July 24, 1996 (61 FR 38407). That action proposed

to require a one-time visual inspection to detect missing rivet heads

or loose rivets of the applicable stringer-to-rib connections in the

upper and lower skin, and repair, if necessary. In lieu of the one-time

visual inspection, or in addition to that inspection, that action also

proposed to require replacement of certain rivets with certain new

rivets in all applicable rib-to-stringer connections of the upper and

lower wings.

Interested persons have been afforded an opportunity to participate

in the making of this amendment. Due consideration has been given to

the comments received.

Support for the Proposal

One commenter supports the proposed rule.

Request to Cite the Latest Dutch AD

One commenter notes that the preamble to the notice stated that

``the RLD classified [Fokker Service Bulletin F27/57-74, dated November

15, 1994] as mandatory and issued Dutch airworthiness directive BLA 93-

094 (A), dated July 16, 1993 * * *.'' The commenter points out that the

reference to BLA 93-094 (A) is incorrect, since that BLA 93-094 (A) was

issued in 1993, a year earlier than the release of Fokker Service

Bulletin F27/57-74. The commenter states that the Dutch BLA that

mandated that service bulletin is BLA 94-148, dated November 24, 1994.

The FAA concurs. The FAA inadvertently referenced the wrong BLA

number and issue date in the preamble to the notice; it should have

referenced BLA 94-148 as the applicable Dutch airworthiness directive.

However, since that information is not restated in this final rule, no

specific change is necessary.

Conclusion

After careful review of the available data, including the comments

noted above, the FAA has determined that air safety and the public

interest require the adoption of the rule with the changes previously

described. The FAA has determined that these changes will neither

increase the economic burden on any operator nor increase the scope of

the AD.

Cost Impact

The FAA estimates that 6 Fokker Model 100, 200, 300, 400, 500, 600,

and 700 series airplanes of U.S. registry will be affected by this AD.

The required inspection will take approximately 4 work hours per

airplane to accomplish, at an average labor rate of $60 per work hour.

Based on these figures, the cost impact of the required inspection

action on U.S. operators is estimated to be $240 per airplane.

The required replacement will take approximately 19 work hours per

airplane to accomplish, at an average labor rate of $60 per work hour.

The cost of required parts will be nominal. Based on these figures, the

cost impact of the required replacement on U.S. operators is estimated

to be $1,140 per airplane.

The cost impact figures discussed above are based on assumptions

that no operator has yet accomplished any of the requirements of this

AD action, and that no operator would accomplish those actions in the

future if this AD were not adopted.

Regulatory Impact

The regulations adopted herein will not have substantial direct

effects on the States, on the relationship between the national

government and the States, or on the distribution of power and

responsibilities among the various levels of government. Therefore, in

accordance with Executive Order 12612,

it is determined that this final rule does not have sufficient

federalism implications to warrant the preparation of a Federalism

Assessment.

For the reasons discussed above, I certify that this action (1) is

not a ``significant regulatory action'' under Executive Order 12866;

(2) is not a ``significant rule'' under DOT Regulatory Policies and

Procedures (44 FR 11034, February 26, 1979); and (3) will not have a

significant economic impact, positive or negative, on a substantial

number of small entities under the criteria of the Regulatory

Flexibility Act. A final evaluation has been prepared for this action

and it is contained in the Rules Docket. A copy of it may be obtained

from the Rules Docket at the location provided under the caption

ADDRESSES.

List of Subjects in 14 CFR Part 39

Air transportation, Aircraft, Aviation safety, Incorporation by

reference, Safety.

Adoption of the Amendment

Accordingly, pursuant to the authority delegated to me by the

Administrator, the Federal Aviation Administration amends part 39 of

the Federal Aviation Regulations (14 CFR part 39) as follows:

PART 39--AIRWORTHINESS DIRECTIVES

1. The authority citation for part 39 continues to read as follows:

Authority: 49 U.S.C. 106(g), 40113, 44701.

Sec. 39.13 [Amended]

2. Section 39.13 is amended by adding the following new

airworthiness directive:

97-01-08 Fokker: Amendment 39-9879. Docket 96-NM-28-AD.

Applicability: Model F27 Mark 100, 200, 300, 400, 500, 600, and

700 series airplanes, serial numbers 10653 through 10692 inclusive;

on which Part 1 of the Accomplishment Instructions of Fokker Service

Bulletins F27/57-68 and F27/57-70 has not been accomplished;

certificated in any category.

Note 1: This AD applies to each airplane identified in the

preceding applicability provision, regardless of whether it has been

modified, altered, or repaired in the area subject to the

requirements of this AD. For airplanes that have been modified,

altered, or repaired so that the performance of the requirements of

this AD is affected, the owner/operator must request approval for an

alternative method of compliance in accordance with paragraph (d) of

this AD. The request should include an assessment of the effect of

the modification, alteration, or repair on the unsafe condition

addressed by this AD; and, if the unsafe condition has not been

eliminated, the request should include specific proposed actions to

address it.

Compliance: Required as indicated, unless accomplished

previously.

To prevent loose or missing rivets at the rib-to-stringer

connections of the upper and lower wing skin at stringers 5 and 6,

which could result in reduced structural integrity of the wings;

accomplish the following:

(a) Except as provided by paragraph (c) of this AD: Prior to the

accumulation of 10,000 total flight cycles, or within 2 months after

the effective date of this AD, whichever occurs later, perform a

one-time visual inspection to detect missing rivet heads or loose

rivets of the applicable stringer-to-rib connections in the upper

and lower skin, in accordance with Part 2 of the Accomplishment

Instructions of Fokker Service Bulletin F27/57-74, dated November

15, 1994.

(1) If no missing rivet head and no loose rivet is detected, no

further action is required by paragraph (a) of this AD.

(2) If any missing rivet head or loose rivet is detected, prior

to further flight, repair the affected rib-to-stringer connection,

in accordance with Part 1 of the Accomplishment Instructions of the

service bulletin.

(b) Prior to the accumulation of 10,000 total flight cycles, or

within 1 year after the effective date of this AD, whichever occurs

later, replace rivets having part number (P/N) MS20600AD4W2 with new

rivets having P/N CR3553P4 in all applicable rib-to-stringer

connections of the upper and lower wings, in accordance with Part 1

of the Accomplishment Instructions of Fokker Service Bulletin F27/

57-74, dated November 15, 1994.

(c) Airplanes on which the replacement required by paragraph (b)

of this AD is performed within the compliance time specified in

paragraph (a) of this AD are not required to accomplish the

inspection required by paragraph (a) of this AD.

(d) An alternative method of compliance or adjustment of the

compliance time that provides an acceptable level of safety may be

used if approved by the Manager, Standardization Branch, ANM-113,

FAA, Transport Airplane Directorate. Operators shall submit their

requests through an appropriate FAA Principal Maintenance Inspector,

who may add comments and then send it to the Manager,

Standardization Branch, ANM-113.

Note 2: Information concerning the existence of approved

alternative methods of compliance with this AD, if any, may be

obtained from the Standardization Branch, ANM-113.

(e) Special flight permits may be issued in accordance with

sections 21.197 and 21.199 of the Federal Aviation Regulations (14

CFR 21.197 and 21.199) to operate the airplane to a location where

the requirements of this AD can be accomplished.

(f) The inspection, repair, and replacement shall be done in

accordance with Fokker Service Bulletin F27/57-74, dated November

15, 1994. This incorporation by reference was approved by the

Director of the Federal Register in accordance with 5 U.S.C. 552(a)

and 1 CFR part 51. Copies may be obtained from Fokker Aircraft USA,

Inc., 1199 North Fairfax Street, Alexandria, Virginia 22314. Copies

may be inspected at the FAA, Transport Airplane Directorate, 1601

Lind Avenue, SW., Renton, Washington; or at the Office of the

Federal Register, 800 North Capitol Street, NW., suite 700,

Washington, DC.

(g) This amendment becomes effective on February 13, 1997.

Issued in Renton, Washington, on January 2, 1997.

S. R. Miller,

Acting Manager, Transport Airplane Directorate, Aircraft Certification

Service.

[FR Doc. 97-362 Filed 1-8-97; 8:45 am]

BILLING CODE 4910-13-U

This is a copy of a public record, reproduced as it was published. It is not legal advice, and it may not be the version a court would rely on. Check the official source before you cite it.

A word about cookies

We need a few to keep you signed in and the library working. The rest help us see which pages people use and where they get stuck. They stay off unless you say yes.