Airworthiness Directives; Beech Aircraft Corporation Model 1900D Airplanes

FederalRegulations

Ask Donna

How this section applies to your facts.

Federal Register › Vol. 61 › 61 FR 1276

This text was captured on Sep 30, 2026. It is a snapshot, not a live feed, so check the official code before relying on it.

Text

DEPARTMENT OF TRANSPORTATION

14 CFR Part 39

[Docket No. 94-CE-33-AD; Amendment 39-9474; AD 95-26-14]

Airworthiness Directives; Beech Aircraft Corporation Model 1900D

Airplanes

AGENCY: Federal Aviation Administration, DOT.

ACTION: Final rule.

-----------------------------------------------------------------------

SUMMARY: This amendment adopts a new airworthiness directive (AD) that

applies to Beech Aircraft Corporation (Beech) Model 1900D airplanes.

This action will require inspecting the cabin partition to ensure that

a right-hand forward partition bracket exists on certain airplanes,

installing this bracket if it does not exist, and improving the right-

hand forward partition installation on all affected airplanes. The

actions specified by this AD are intended to prevent cabin partition

failure because of a structural deficiency in the bracket or if the

bracket is not installed, which, if not detected and corrected, could

cause passenger injury if the partition could not withstand the load

incurred with the baggage compartment loaded to its 250-pound limit.

DATES: Effective January 31, 1996.

The incorporation by reference of certain publications listed in

the regulations is approved by the Director of the Federal Register as

of January 31, 1996.

ADDRESSES: Service information that applies to this AD may be obtained

from the Beech Aircraft Corporation, P.O. Box 85, Wichita, Kansas

67201-0085. This information may also be examined at the Federal

Aviation Administration (FAA), Central Region, Office of the Assistant

Chief Counsel, Attention: Rules Docket 94-CE-33-AD, Room 1558, 601 E.

12th Street, Kansas City, Missouri 64106; or at the Office of the

Federal Register, 800 North Capitol Street, NW., suite 700, Washington,

DC.

FOR FURTHER INFORMATION CONTACT: Mr. Steve Potter, Aerospace Engineer,

Wichita Aircraft Certification Office, FAA, 1801 Airport Road, Mid-

Continent Airport, Wichita, Kansas 67209; telephone (316) 946-4124;

facsimile (316) 946-4407.

SUPPLEMENTARY INFORMATION: A proposal to amend part 39 of the Federal

Aviation Regulations (14 CFR part 39) to include an AD that would apply

to Beech Model 1900D airplanes was published in the Federal Register on

April 17, 1995 (60 FR 19172). The action proposed to require inspecting

the right-hand forward partition on certain serial number airplanes to

ensure that the partition bracket exists, installing this bracket if it

does not exist, and incorporating a structural improvement to the

right-hand forward partition on all affected airplanes. Accomplishment

of the proposed action will be in accordance with Kit Drawing No. 129-

5007, as referenced in Beech Service Bulletin No. 2556, Revision 1,

dated February 1995.

Interested persons have been afforded an opportunity to participate

in the making of this amendment. No comments were received on the

proposed rule or the FAA's determination of the cost to the public.

Since issuance of the NPRM, the FAA realized that it inadvertently

miscalculated the cost impact upon the public, specifically the number

of airplanes affected and the number of workhours necessary to

accomplish the actions. The final rule has been revised to incorporate

these updated cost figures. The FAA does not believe that these changes

will adversely affect this AD action.

After careful review of all available information related to the

subject presented above, the FAA has determined that air safety and the

public interest require the adoption of the rule as proposed except for

minor editorial corrections. The FAA has determined that these minor

corrections will not change the meaning of the AD and will not add any

additional burden upon the public than was already proposed.

The FAA estimates that 83 airplanes in the U.S. registry will be

affected by the required inspection and possible installation and 91

airplanes worldwide will be affected by the required modification. The

required inspection and possible installation will take approximately 6

workhours per airplane to accomplish and the required modification will

take approximately 4 workhours to accomplish, with a labor rate of $60

an hour. Parts for the required modification cost approximately $650

per airplane. Based on these figures, the total cost impact of the AD

on U.S. operators is estimated to be $103,750. This figure is based on

the assumption that no owner/operator of the affected airplanes has

accomplished the modification and no airplane has a right-hand forward

partition bracket installed and would need one installed.

Beech has informed the FAA that it has distributed parts (Kit No.

129-5007-1 S) to accommodate approximately 58 of the affected

airplanes. Assuming that each of these distributed kits is incorporated

on one of the affected airplanes, the cost of this AD would be further

reduced by $72,500 from $103,750 to $31,250.

The regulations adopted herein will not have substantial direct

effects on the States, on the relationship between the national

government and the States, or on the distribution of power and

responsibilities among the various levels of government. Therefore, in

accordance with Executive Order 12612, it is determined that this final

rule does not have sufficient federalism implications to warrant the

preparation of a Federalism Assessment.

For the reasons discussed above, I certify that this action (1) is

not a ``significant regulatory action'' under Executive Order 12866;

(2) is not a ``significant rule'' under DOT Regulatory Policies and

Procedures (44 FR 11034, February 26, 1979); and (3) will not have a

significant economic impact, positive or negative, on a substantial

number of small entities under the criteria of the Regulatory

Flexibility Act. A copy of the final evaluation prepared for this

action is contained in the Rules Docket. A copy of it may be obtained

by contacting the Rules Docket at the location provided under the

caption ADDRESSES.

List of Subjects in 14 CFR Part 39

Air transportation, Aircraft, Aviation safety, Incorporation by

reference, Safety.

Adoption of the Amendment

Accordingly, pursuant to the authority delegated to me by the

Administrator, the Federal Aviation Administration amends part 39 of

the Federal Aviation Regulations (14 CFR part 39) as follows:

PART 39--AIRWORTHINESS DIRECTIVES

1. The authority citation for part 39 continues to read as follows:

Authority: 49 USC 106(g), 40101, 40113, 44701.

Sec. 39.13 [Amended]

2. Section 39.13 is amended by adding a new airworthiness directive

(AD) to read as follows:

AD NO. 95-26-14 Beech Aircraft Corporation: Amendment 39-9474;

Docket No. 94-CE-33-AD.

Applicability: Model 1900D airplanes, serial numbers UE-2

through UE-92, certificated in any category.

Note 1: This AD applies to each airplane identified in the

preceding applicability revision, regardless of whether it has been

modified, altered, or repaired in the area subject to the

requirements of this AD. For airplanes that have been modified,

altered, or repaired so that the performance of the requirements of

this AD is affected, the owner/operator must request approval for an

alternative method of compliance in accordance with paragraph (d) of

this AD. The request should include an assessment of the effect of

the modification, alteration, or repair on the unsafe condition

addressed by this AD; and, if the unsafe condition has not been

eliminated, the request should include specific proposed actions to

address it.

Compliance: Required within the next 400 hours time-in-service

(TIS) after the effective date of this AD, unless already

accomplished.

To prevent cabin partition failure because of a structural

deficiency, which, if not detected and corrected, could cause

passenger injury if the partition could not withstand the load

incurred with the baggage compartment loaded to its 250-pound limit,

accomplish the following:

(a) For airplanes incorporating one of the following serial

numbers: UE-2 through UE-68, UE-70 through UE-72, or UE-74 through

UE-77, inspect the cabin partition to ensure that a right-hand

partition bracket, part number (P/N) 129-530043-79, exists. If this

bracket does not exist, prior to further flight, install this

bracket with P/N MS27039-1-09 screws and P/N AN960PD10 washers in

accordance with Kit Drawing No. 129-5007 as referenced in Beech

Service Bulletin (SB) No. 2556, Revision 1, dated February 1995.

(b) For all affected serial numbers (UE-2 through UE-92),

improve the right-hand forward partition installation in accordance

with Kit Drawing No. 129-5007, as referenced in Beech SB No. 2556,

Revision 1, dated February 1995.

(c) Special flight permits may be issued in accordance with

sections 21.197 and 21.199 of the Federal Aviation Regulations (14

CFR 21.197 and 21.199) to operate the airplane to a location where

the requirements of this AD can be accomplished.

(d) An alternative method of compliance or adjustment of the

compliance time that provides an equivalent level of safety may be

approved by the Manager, Wichita Aircraft Certification Office

(ACO), 1801 Airport Road, Room 100, Mid-Continent Airport, Wichita,

Kansas 67209. The request shall be forwarded through an appropriate

FAA Maintenance Inspector, who may add comments and then send it to

the Manager, Wichita ACO.

Note 2: Information concerning the existence of approved

alternative methods of compliance with this AD, if any, may be

obtained from the Wichita ACO.

(e) The installation and modification required by this AD shall

be done in accordance with Kit Drawing No. 129-5007, as referenced

in Beech Service Bulletin No. 2556, Revision 1, dated February 1995.

This incorporation by reference was approved by the Director of the

Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR part

51. Copies may be obtained from the Beech Aircraft Corporation, P.O.

Box 85, Wichita, Kansas 67201-0085. Copies may be inspected at the

FAA, Central Region, Office of the Assistant Chief Counsel, Room

1558, 601 E. 12th Street, Kansas City, Missouri, or at the Office of

the Federal Register, 800 North Capitol Street, NW., 7th Floor,

suite 700, Washington, DC.

(f) This amendment (39-9474) becomes effective on January 31,

1996.

Issued in Kansas City, Missouri, on December 20, 1995.

Dwight A. Young,

Acting Manager, Small Airplane Directorate, Aircraft Certification

Service.

[FR Doc. 96-483 Filed 1-18-96; 8:45 am]

BILLING CODE 4910-13-U

This is a copy of a public record, reproduced as it was published. It is not legal advice, and it may not be the version a court would rely on. Check the official source before you cite it.

A word about cookies

We need a few to keep you signed in and the library working. The rest help us see which pages people use and where they get stuck. They stay off unless you say yes.

Airworthiness Directives; Beech Aircraft Corporation Model 1900D Airplanes · 61 FR 1276 | Frix