Airworthiness Directives; Raytheon Aircraft Company Models C90A, B200, B200C, B200T, B200CT, 300, B300, B300C, and A200CT Airplanes

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 39

[Docket No. 98-CE-104-AD]

RIN 2120-AA64

Airworthiness Directives; Raytheon Aircraft Company Models C90A,

B200, B200C, B200T, B200CT, 300, B300, B300C, and A200CT Airplanes

AGENCY: Federal Aviation Administration, DOT.

ACTION: Notice of proposed rulemaking (NPRM).

-----------------------------------------------------------------------

SUMMARY: This document proposes to adopt a new airworthiness directive

(AD) that would apply to certain Raytheon Aircraft Company (Raytheon)

Models C90A, B200, B200C, B200T, B200CT, 300, B300, B300C, and A200CT

airplanes. The proposed AD would require installing a filter element in

the landing gear hand pump suction line. The proposed AD is the result

of reports of the potential for debris to enter the landing gear hand

pump and interfere with its operation, which could prevent the nose

landing gear from being extended manually. Two occurrences were

reported of nose landing gear collapse after manual extension. The

actions specified by the proposed AD are intended to prevent the

inability to extend the landing gear with the hand pump caused by

debris entering the landing gear hand pump, which could result in

passenger injury or damage to the airplane if manual operation of the

landing gear failed.

DATES: Comments must be received on or before March 8, 1999.

ADDRESSES: Submit comments in triplicate to the Federal Aviation

Administration (FAA), Central Region, Office of the Regional Counsel,

Attention: Rules Docket No. 98-CE-104-AD, Room 1558, 601 E. 12th

Street, Kansas City, Missouri 64106. Comments may be inspected at this

location between 8 a.m. and 4 p.m., Monday through Friday, holidays

excepted.

Service information that applies to the proposed AD may be obtained

from the Raytheon Aircraft Company, P.O. Box 85, Wichita, Kansas 67201-

0085. This information also may be examined at the Rules Docket at the

address above.

m 1558, 601 E. 12th

Street, Kansas City, Missouri 64106. Comments may be inspected at this

location between 8 a.m. and 4 p.m., Monday through Friday, holidays

excepted.

Service information that applies to the proposed AD may be obtained

from the Raytheon Aircraft Company, P.O. Box 85, Wichita, Kansas 67201-

0085. This information also may be examined at the Rules Docket at the

address above.

FOR FURTHER INFORMATION CONTACT: Mr. Paul DeVore, Aerospace Engineer,

FAA, Wichita Aircraft Certification Office, 1801 Airport Road, Mid-

Continent Airport, Wichita, Kansas 67209; telephone: (316) 946-4142;

facsimile: (316) 946-4407.

SUPPLEMENTARY INFORMATION:

Comments Invited

Interested persons are invited to participate in the making of the

proposed rule by submitting such written data, views, or arguments as

they may desire. Communications should identify the Rules Docket number

and be submitted in triplicate to the address specified above. All

communications received on or before the closing date for comments,

specified above, will be considered before taking action on the

proposed rule. The proposals contained in this notice may be changed in

light of the comments received.

Comments are specifically invited on the overall regulatory,

economic, environmental, and energy aspects of the proposed rule. All

comments submitted will be available, both before and after the closing

date for comments, in the Rules Docket for examination by interested

persons. A report that summarizes each FAA-public contact concerned

with the substance of this proposal will be filed in the Rules Docket.

Commenters wishing the FAA to acknowledge receipt of their comments

submitted in response to this notice must submit a self-addressed,

stamped postcard on which the following statement is made: ``Comments

to Docket No. 98-CE-104-AD.'' The postcard will be date stamped and

returned to the commenter.

Availability of NPRMs

with the substance of this proposal will be filed in the Rules Docket.

Commenters wishing the FAA to acknowledge receipt of their comments

submitted in response to this notice must submit a self-addressed,

stamped postcard on which the following statement is made: ``Comments

to Docket No. 98-CE-104-AD.'' The postcard will be date stamped and

returned to the commenter.

Availability of NPRMs

Any person may obtain a copy of this NPRM by submitting a request

to the FAA, Central Region, Office of the Regional Counsel, Attention:

Rules Docket No. 98-CE-104-AD, Room 1558, 601 E. 12th Street, Kansas

City, Missouri 64106.

Discussion

The FAA has received reports of the potential for debris to enter

the landing gear hand pump and interfere with its operation on certain

Raytheon Models C90A, B200, B200C, B200T, B200CT, 300, B300, B300C, and

A200CT airplanes. This could prevent the nose landing gear from being

properly extended manually. Two occurrences were reported of nose

landing gear collapse after manual extension.

This condition, if not corrected in a timely manner, could result

in the inability to extend the landing gear with the hand pump with

consequent passenger injury or damage to the airplane if manual

operation of the landing gear failed.

Relevant Service Information

Raytheon has issued Mandatory Service Bulletin SB 32-3073, Revision

1, Issued: March, 1998, Revised: July 1998. This service bulletin

includes procedures for installing a filter element in the landing gear

hand pump suction line.

The FAA's Determination

After examining the circumstances and reviewing all available

information related to the incidents described above, the FAA has

determined that AD action should be taken to prevent the inability to

extend the landing gear with the hand pump caused by debris entering

the landing gear hand pump. This could result in passenger injury or

damage to the airplane if manual operation of the landing gear failed.

Explanation of the Provisions of the Proposed AD

information related to the incidents described above, the FAA has

determined that AD action should be taken to prevent the inability to

extend the landing gear with the hand pump caused by debris entering

the landing gear hand pump. This could result in passenger injury or

damage to the airplane if manual operation of the landing gear failed.

Explanation of the Provisions of the Proposed AD

Since an unsafe condition has been identified that is likely to

exist or develop in other Raytheon Models C90A, B200, B200C, B200T,

B200CT, 300, B300, B300C, and A200CT airplanes of the same type design,

the FAA is proposing AD action. The proposed AD would require

installing a filter element in the landing gear hand pump suction line.

Accomplishment of the proposed action would be required in accordance

with the service information previously referenced.

Cost Impact

The FAA estimates that 991 airplanes in the U.S. registry would be

affected by the proposed AD, that it would take approximately 5

workhours per airplane to accomplish the proposed action, and that the

average labor rate is approximately $60 an hour. Raytheon will give

warranty credit for parts until July 31, 1999. Based on these figures,

the total cost impact of the proposed AD on U.S. operators is estimated

to be $297,300, or $300 per airplane.

Regulatory Impact

The regulations proposed herein would not have substantial direct

effects on the States, on the relationship between the national

government and the States, or on the distribution of power and

responsibilities among the various levels of government. Therefore, in

accordance with Executive Order 12612, it is determined that this

proposal would not have sufficient federalism implications to warrant

the preparation of a Federalism Assessment.

For the reasons discussed above, I certify that this action (1) is

not a ``significant regulatory action'' under Executive Order 12866;

er and

responsibilities among the various levels of government. Therefore, in

accordance with Executive Order 12612, it is determined that this

proposal would not have sufficient federalism implications to warrant

the preparation of a Federalism Assessment.

For the reasons discussed above, I certify that this action (1) is

not a ``significant regulatory action'' under Executive Order 12866;

(2) is not a ``significant rule'' under DOT Regulatory Policies and

Procedures (44 FR 11034, February 26, 1979); and (3) if promulgated,

will not have a significant economic impact, positive or negative, on a

substantial number of small entities under the criteria of the

Regulatory Flexibility Act. A copy of the draft regulatory evaluation

prepared for this action has been placed in the Rules Docket. A copy of

it may be obtained by contacting the Rules Docket at the location

provided under the caption ADDRESSES.

List of Subjects in 14 CFR Part 39

Air transportation, Aircraft, Aviation safety, Safety.

The Proposed Amendment

Accordingly, pursuant to the authority delegated to me by the

Administrator, the Federal Aviation Administration proposes to amend

part 39 of the Federal Aviation Regulations (14 CFR part 39) as

follows:

PART 39--AIRWORTHINESS DIRECTIVES

1. The authority citation for part 39 continues to read as follows:

Authority: 49 U.S.C. 106(g), 40113, 44701.

Sec. 39.13 [Amended]

2. Section 39.13 is amended by adding a new airworthiness directive

(AD) to read as follows:

Raytheon Aircraft Company (All type certificates of the affected

airplanes previously held by the Beech Aircraft Corporation): Docket

No. 98-CE-104-AD.

Applicability: The following airplane models and serial numbers,

certificated in any category:

U.S.C. 106(g), 40113, 44701.

Sec. 39.13 [Amended]

2. Section 39.13 is amended by adding a new airworthiness directive

(AD) to read as follows:

Raytheon Aircraft Company (All type certificates of the affected

airplanes previously held by the Beech Aircraft Corporation): Docket

No. 98-CE-104-AD.

Applicability: The following airplane models and serial numbers,

certificated in any category:

------------------------------------------------------------------------

Models Serial Numbers

------------------------------------------------------------------------

C90A............................. LJ-1063 through LJ-1482.

B200............................. BB-1158, BB-1167, BB-1193 through BB-

1532, and all serial numbers with

Beech Kit 101-8018 incorporated.

B200C............................ BL-113 through BL-117, BL-124 through

BL-140, and all serial numbers with

Beech Kit 101-8018 incorporated

B200T............................ BT-31 through BT-38, and all serial

numbers with Beech Kit 101-8018

incorporated.

B200CT........................... BN-2, BN-3, and BN-4 that have Beech

Kit 101-8018 incorporated.

B200CT........................... FG-1 and FG-2.

300.............................. FA-1 through FA-230.

300.............................. FF-1 through FF-19.

B300............................. FL-1 through FL-138.

B300C............................ FM-1 through FM-9.

B300C............................ FN-1.

d, the owner/operator must request approval for an

alternative method of compliance in accordance with paragraph (c) of

this AD. The request should include an assessment of the effect of

the modification, alteration, or repair on the unsafe condition

addressed by this AD; and, if the unsafe condition has not been

eliminated, the request should include specific proposed actions to

address it.

Compliance: Required within the next 200 hours time-in-service

(TIS) after the effective date of this AD, unless already

accomplished.

To prevent the inability to extend the landing gear with the

hand pump caused by debris entering the landing gear hand pump,

which could result in passenger injury or damage to the airplane if

manual operation of the landing gear failed, accomplish the

following:

(a) Install a filter element in the landing gear hand pump

suction line, in accordance with the ACCOMPLISHMENT INSTRUCTIONS

section of Raytheon Mandatory Service Bulletin SB 32-3073, Revision

1, Issued: March, 1998, Revised: July 1998.

(b) Special flight permits may be issued in accordance with

sections 21.197 and 21.199 of the Federal Aviation Regulations (14

CFR 21.197 and 21.199) to operate the airplane to a location where

the requirements of this AD can be accomplished.

(c) An alternative method of compliance or adjustment of the

compliance time that provides an equivalent level of safety may be

approved by the Manager, Wichita Aircraft Certification Office

(ACO), 1801 Airport Road, Room 100, Mid-Continent Airport, Wichita,

Kansas 67209. The request shall be forwarded through an appropriate

FAA Maintenance Inspector, who may add comments and then send it to

the Manager, Wichita ACO.

Note 2: Information concerning the existence of approved

alternative methods of compliance with this AD, if any, may be

obtained from the Wichita ACO.

tion Office

(ACO), 1801 Airport Road, Room 100, Mid-Continent Airport, Wichita,

Kansas 67209. The request shall be forwarded through an appropriate

FAA Maintenance Inspector, who may add comments and then send it to

the Manager, Wichita ACO.

Note 2: Information concerning the existence of approved

alternative methods of compliance with this AD, if any, may be

obtained from the Wichita ACO.

(d) All persons affected by this directive may obtain copies of

the document referred to herein upon request to the Raytheon

Aircraft Company, P.O. Box 85, Wichita, Kansas 67201-0085; or may

examine this document at the FAA, Central Region, Office of the

Regional Counsel, Room 1558, 601 E. 12th Street, Kansas City,

Missouri 64106.

Issued in Kansas City, Missouri, on December 28, 1998.

Marvin R. Nuss,

Acting Manager, Small Airplane Directorate, Aircraft Certification

Service.

[FR Doc. 99-44 Filed 1-4-99; 8:45 am]

BILLING CODE 4910-13-U