Airworthiness Directives; Raytheon Corporate Jets Model BAe 125- 1000A Series Airplanes

DEPARTMENT OF TRANSPORTATION

14 CFR Part 39

[Docket No. 94-NM-67-AD; Amendment 39-9096; AD 94-25-12]

Airworthiness Directives; Raytheon Corporate Jets Model BAe 125-

1000A Series Airplanes

AGENCY: Federal Aviation Administration, DOT.

ACTION: Final rule.

-----------------------------------------------------------------------

SUMMARY: This amendment adopts a new airworthiness directive (AD),

applicable to certain Raytheon Corporate Jets Model BAe 125-1000A

series airplanes, that requires modification of the galley feeder

cables and toilet services fuse. This amendment is prompted by a report

that the gauge size of the existing galley feeder cable is not

compatible with the rating of the currently used toilet services fuse.

The actions specified by this AD are intended to ensure that the

subject cables are compatible with the toilet services fuse in order to

prevent overheating of the cables, which could result in smoke and fire

in the cabin.

DATES: Effective on January 26, 1995.

The incorporation by reference of certain publications listed in

the regulations is approved by the Director of the Federal Register as

of January 26, 1995.

ADDRESSES: The service information references in this AD may be

obtained from Raytheon Corporate Jets, Inc., 3 Bishops Square Street,

Albans Road West, Hatfield, Hertfordshire, AL109NE, United Kingdom.

This information may be examined at the Federal Aviation Administration

(FAA), Transport Airplane Directorate, Rules Docket, 1601 Lind Avenue,

SW., Renton, Washington; or at the Office of the Federal Register, 800

North Capitol Street, NW., suite 700, Washington, DC.

FOR FURTHER INFORMATION CONTACT: William Schroeder, Aerospace Engineer,

Standardization Branch, ANM-113, FAA, Transport Airplane Directorate,

1601 Lind Avenue, SW., Renton, Washington 98055-4056; telephone (206)

227-2148; fax (206) 227-1320.

SUPPLEMENTARY INFORMATION: A proposal to amend part 39 of the Federal

Aviation Regulations (14 CFR part 39) to include an airworthiness

directive (AD) that is applicable to certain Raytheon Corporate Jets

Model BAe 125-1000A series airplanes was published in the Federal

Register on July 5, 1994 (59 FR 34396). That action proposed to require

modification of the galley feeder cables and toilet services fuse.

Interested persons have been afforded an opportunity to participate

in the making of this amendment. No comments were submitted in response

to the proposal or the FAA's determination of the cost to the public.

The FAA has recently reviewed the figures it has used over the past

several years in calculating the economic impact of AD activity. In

order to account for various inflationary costs in the airline

industry, the FAA has determined that it is necessary to increase the

labor rate used in these calculations from $55 per work hour to $60 per

work hour. The economic impact information, below has been revised to

reflect this increase in the specified hourly labor rate.

As a result of recent communications with the Air Transport

Association (ATA) of America, the FAA has learned that, in general,

some operators may misunderstand the legal effect of AD's on airplanes

that are identified in the applicability provision of the AD, but that

have been altered or repaired in the area addressed by the AD. Under

these circumstances, at least one operator appears to have incorrectly

assumed that its airplane was not subject to an AD. On the contrary,

all airplanes identified in the applicability provision of an AD are

legally subject to the AD. If an airplane has been altered or repaired

in the affected area in such a way as to affect compliance with the AD,

the owner or operator is required to obtain FAA approval for an

alternative method of compliance with the AD, in accordance with the

paragraph of each AD that provides for such approvals. A note has been

added to this final rule to clarify this requirement. The FAA has

determined that this addition will neither increase the economic burden

on any operator nor increase the scope of the AD.

The FAA estimates that 4 airplanes of U.S. registry will be

affected by this AD, that it will take approximately 16 work hours per

airplane to accomplish the required actions, and that the average labor

rate is $60 per work hour. Required parts will cost approximately $500

per airplane. Based on these figures, the total cost impact of the AD

on U.S. operators is estimated to be $5,840, or $1,460 per airplane.

The total cost impact figure discussed above is based on

assumptions that no operator has yet accomplished any of the

requirements of this AD action, and that no operator would accomplish

those actions in the future if this AD were not adopted.

The regulations adopted herein will not have substantial direct

effects on the States, on the relationship between the national

government and the States, or on the distribution of power and

responsibilities among the various levels of government. Therefore, in

accordance with Executive Order 12612, it is determined that this final

rule does not have sufficient federalism implications to warrant the

preparation of a Federalism Assessment.

For the reasons discussed above, I certify that this action (1) is

not a ``significant regulatory action'' under Executive Order 12866;

(2) is not a ``significant rule'' under DOT Regulatory Policies and

Procedures (44 FR 11034, February 26, 1979); and (3) will not have a

significant impact, positive or negative, on a substantial number of

small entities under the criteria of the Regulatory Flexibility Act. A

final evaluation has been prepared for this action and it is contained

in the Rules Docket. A copy of it may be obtained from the Rules Docket

at the location provided under the caption ADDRESSES.

List of Subjects in 14 CFR Part 39

Air transportation, Aircraft, Aviation safety, Incorporation by

reference, Safety.

Adoption of the Amendment

Accordingly, pursuant to the authority delegated to me by the

Administrator, the Federal Aviation Administration amends part 39 of

the Federal Aviation Regulations (14 CFR part 39) as follows:

PART 39--AIRWORTHINESS DIRECTIVES

1. The authority citation for part 39 continues to read as follows:

Authority: 49 U.S.C. App. 1354(a), 1421 and 1423; 49 U.S.C.

106(g); and 14 CFR 11.89.

Sec. 39.13 [Amended]

2. Section 39.13 is amended by adding the following new

airworthiness directive:

94-25-12 Raytheon Corporate Jets, Inc.: Amendment 39-9096. Docket

94-NM-67-AD.

Applicability: Model BAe 125-1000A series airplanes; as listed

in Hawker-Raytheon Corporate Jets Service Bulletin SB.25-76-

25A698A&B, dated February 10, 1994, and Hawker-Raytheon Corporate

Jets Service Bulletin SB.25-75-25A699A, dated February 10, 1994;

certificated in any category.

Note 1: This AD applies to each airplane identified in the

preceding applicability provision, regardless of whether it has been

modified, altered, or repaired in the area subject to the

requirements of this AD. For airplanes that have been modified,

altered, or repaired so that the performance of the requirements of

this AD is affected, the owner/operator must use the authority

provided in paragraph (c) to request approval from the FAA. This

approval may address either no action, if the current configuration

eliminates the unsafe condition; or different actions necessary to

address the unsafe condition described in this AD. Such a request

should include an assessment of the effect of the changed

configuration on the unsafe condition addressed by this AD. In no

case does the presence of any modification, alteration, or repair

remove any airplane from the applicability of this AD.

Compliance: Required as indicated, unless accomplished

previously.

To prevent smoke and fire in the cabin due to overheating of

galley cables, accomplish the following:

(a) For airplanes listed in Hawker-Raytheon Corporate Jets

Service Bulletin SB.25-76-25A698A&B, dated February 10, 1994: With

100 hours time-in-service after the effective date of this AD,

install Modification 25A698A&B in accordance with that service

bulletin.

(b) For airplanes listed in Hawker-Raytheon Corporate Jets

Service Bulletin SB.25-75-25A699A, dated February 10, 1994: Within

100 hours time-in-service after the effective date of this AD,

install Modification 25A699A in accordance with that service

bulletin.

(c) An alternative method of compliance or adjustment of the

compliance time that provides an acceptable level of safety may be

used if approved by the Manager, Standardization Branch, AMS-113,

FAA, Transport Airplane Directorate. Operators shall submit their

requests through an appropriate FAA Principal Maintenance Inspector,

who may add comments and then send it to the Manager,

Standardization Branch, ANM-113.

Note 2: Information concerning the existence of approved

alternative methods of compliance with this AD, if any, may be

obtained from the Standardization Branch, ANM-113.

(d) Special flight permits may be issued in accordance with

Secs. 21.197 and 21.199 of the Federal Aviation Regulations (14 CFR

21.197 and 21.199) to operate the airplane to a location where the

requirements of this AD can be accomplished.

(e) The installation shall be done in accordance with Hawker-

Raytheon Corporate Jets Service Bulletin SB.25-76-25A698A&B, dated

February 10, 1994, or Hawker-Raytheon Corporate Jets Service

Bulletin SB.25-75-25A699A, dated February 10, 1994, as applicable.

This incorporation by reference was approved by the Director of the

Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR part

51. Copies may be obtained from Raytheon Corporate Jets, Inc.,

Customer Support Department, Adams Field, P.O. Box 3356, Little

Rock, Arkansas 72203. Copies may be inspected at the FAA, Transport

Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington; or

at the Office of the Federal Register, 800 North Capitol Street,

NW., suite 700, Washington, DC.

(f) This amendment becomes effective on January 26, 1995.

Issued in Renton, Washington, on December 5, 1994.

Darrell M. Pederson,

Acting Manager, Transport Airplane Directorate, Aircraft Certification

Service.

[FR Doc. 94-30398 Filed 12-23-94; 8:45 am]

BILLING CODE 4910-13-M