Decision That Nonconforming 1992 BMW 7 Series Passenger Cars Are Eligible for Importation

Federal RegisterJan 12, 1998

Ask Donna

What actually matters in this document.

Text

DEPARTMENT OF TRANSPORTATION

National Highway Traffic Safety Administration

[Docket No. NHTSA-97-3056]

Decision That Nonconforming 1992 BMW 7 Series Passenger Cars Are

Eligible for Importation

AGENCY: National Highway Traffic Safety Administration (NHTSA), DOT.

ACTION: Notice of decision by NHTSA that nonconforming 1992 BMW 7

Series passenger cars are eligible for importation.

-----------------------------------------------------------------------

SUMMARY: This notice announces the decision by NHTSA that 1992 BMW 7

Series passenger cars not originally manufactured to comply with all

applicable Federal motor vehicle safety standards are eligible for

importation into the United States because they are substantially

similar to vehicles originally manufactured for importation into and

sale in the United States and certified by their manufacturer as

complying with the safety standards (the U.S. certified version of the

1992 BMW 7 Series), and they are capable of being readily altered to

conform to the standards.

DATES: This decision is effective January 12, 1998.

[[Page 1882]]

FOR FURTHER INFORMATION CONTACT: George Entwistle, Office of Vehicle

Safety Compliance, NHTSA (202-366-5306).

SUPPLEMENTARY INFORMATION:

Background

Under 49 U.S.C. 30141(a)(1)(A), a motor vehicle that was not

originally manufactured to conform to all applicable Federal motor

vehicle safety standards shall be refused admission into the United

States unless NHTSA has decided that the motor vehicle is substantially

similar to a motor vehicle originally manufactured for importation into

and sale in the United States, certified under 49 U.S.C. 30115, and of

the same model year as the model of the motor vehicle to be compared,

and is capable of being readily altered to conform to all applicable

Federal motor vehicle safety standards.

Petitions for eligibility decisions may be submitted by either

manufacturers or importers who have registered with NHTSA pursuant to

49 CFR Part 592. As specified in 49 CFR 593.7, NHTSA publishes notice

in the Federal Register of each petition that it receives, and affords

interested persons an opportunity to comment on the petition. At the

close of the comment period, NHTSA decides, on the basis of the

petition and any comments that it has received, whether the vehicle is

eligible for importation. The agency then publishes this decision in

the Federal Register.

J.K. Motors of Kingsville, Maryland (``J.K.'') (Registered Importer

90-006) petitioned NHTSA to decide whether 1992 BMW 7 Series passenger

cars are eligible for importation into the United States. NHTSA

published notice of the petition on November 10, 1997 (62 FR 60556) to

afford an opportunity for public comment. The reader is referred to

that notice for a thorough description of the petition.

One comment was received in response to the notice of the petition,

from BMW of North America, Inc. (``BMW''), the United States

representative of Bayerische Motoren Werke, A.G., the vehicle's

manufacturer. In this comment, BMW stated that the petition erroneously

claimed that non-U.S. certified 1992 BMW 7 Series passenger cars are

equipped in both front seating positions with an automatic belt system

identical to that found on the vehicles' U.S. certified counterparts.

BMW stated that the company never certified the U.S. version of the

1992 BMW 7 Series to FMVSS No. 208, Occupant Crash Protection, through

the use of automatic seat belts, and that it installed frontal air bag

systems in those vehicles instead. BMW contended that air bags would

have to be installed in a non-U.S. certified 1992 BMW 7 Series for that

vehicle to comply with FMVSS No. 208.

According to BMW, it would be ``extremely difficult, if not

impossible,'' for an air bag system to be properly installed.

NHTSA accorded J.K. an opportunity to respond to BMW's comment. In

its response, J.K. acknowledged that the petition was in error to the

extent that it described non-U.S. certified 1992 BMW 7 Series passenger

cars as being equipped with automatic seat belts. J.K. agreed with

BMW's assertion that these vehicles are equipped with air bag systems

at both front outboard seating positions. Because the air bags in 1992

BMW 7 Series passenger cars manufactured for the European market are

smaller than those furnished on the U.S. certified version of that

vehicle, J.K. stated that it would be necessary to replace the air bags

in European market vehicles with U.S. model components. J.K. did not

address the difficulty of making such a replacement, although it

indicated that if there were no existing air bag system in these

vehicles, it would be possible to install one by changing the steering

column and adding the necessary wiring and sensors to existing mounts.

NHTSA believes that J.K.'s response adequately addresses the issue

that BMW has raised regarding its petition. NHTSA further notes that in

recent years, air bag systems have been replaced with relative ease on

BMWs and other similar vehicles, and that the need for this alteration

would not preclude the non-U.S. certified 1992 BMW 7 Series from being

found eligible for importation.

NHTSA has accordingly decided to grant the petition.

Vehicle Eligibility Number for Subject Vehicles

The importer of a vehicle admissible under any final decision must

indicate on the form HS-7 accompanying entry the appropriate vehicle

eligibility number indicating that the vehicle is eligible for entry.

VSP-232 is the vehicle eligibility number assigned to vehicles

admissible under this notice of final decision.

Final Decision

Accordingly, on the basis of the foregoing, NHTSA hereby decides

that a 1992 BMW 7 Series passenger car is substantially similar to a

1992 BMW 7 Series passenger car originally manufactured for importation

into and sale in the United States and certified under 49 U.S.C.

Sec. 30115, and is capable of being readily altered to conform to all

applicable Federal motor vehicle safety standards.

Authority: 49 U.S.C. 30141(a)(1)(A) and (b)(1); 49 CFR 593.8;

delegations of authority at 49 CFR 1.50 and 501.8.

Issued on: January 7, 1998.

Marilynne Jacobs,

Director, Office of Vehicle Safety Compliance.

[FR Doc. 98-690 Filed 1-9-98; 8:45 am]

BILLING CODE 4910-59-P

This is a copy of a public record, reproduced as it was published. It is not legal advice, and it may not be the version a court would rely on. Check the official source before you cite it.

A word about cookies

We need a few to keep you signed in and the library working. The rest help us see which pages people use and where they get stuck. They stay off unless you say yes.