Approval and Promulgation of State Implementation Plans; California State Implementation Plan Revision, Santa Barbara County, Ventura County, Monterey Bay Unified, and Placer County Air Pollution Control District; and Yolo Solano Air Quality Management District

ENVIRONMENTAL PROTECTION AGENCY

40 CFR Part 52

[CA 33-3-7130b; FRL-5339-8]

Approval and Promulgation of State Implementation Plans;

California State Implementation Plan Revision, Santa Barbara County,

Ventura County, Monterey Bay Unified, and Placer County Air Pollution

Control District; and Yolo Solano Air Quality Management District

AGENCY: Environmental Protection Agency (EPA).

ACTION: Proposed rule.

-----------------------------------------------------------------------

SUMMARY: EPA is proposing to approve revisions to the California State

Implementation Plan (SIP) which concern the control of volatile organic

compound (VOC) emissions from the following: the coating or assembly of

[[Page 5359]]

aircraft or aerospace vehicle parts and products, the use of organic

solvents and organic solvent cleaners, the coating of miscellaneous

metal parts and products, the application of adhesives, and the coating

of flat wood paneling.

The intended effect of proposing approval of these rules is to

regulate emissions of VOCs in accordance with the requirements of the

Clean Air Act, as amended in 1990 (CAA or the Act). In the Final Rules

Section of this Federal Register, the EPA is approving the state's SIP

revision as a direct final rule without prior proposal because the

Agency views this as a noncontroversial revision amendment and

anticipates no adverse comments. A detailed rationale for this approval

is set forth in the direct final rule. If no adverse comments are

received in response to this proposed rule, no further activity is

contemplated in relation to this rule. If EPA receives adverse

comments, the direct final rule will be withdrawn and all public

comments received will be addressed in a subsequent final rule based on

this proposed rule. The EPA will not institute a second comment period

on this document. Any parties interested in commenting on this action

should do so at this time.

DATES: Comments on this proposed rule must be received in writing by

March 13, 1996.

ADDRESSES: Written comments on this action should be addressed to:

Daniel A. Meer, Rulemaking Section (A-5-3), Air and Toxics Division,

U.S. Environmental Protection Agency, Region 9, 75 Hawthorne Street,

San Francisco, CA 94105-3901.

Copies of the rule revisions and EPA's evaluation report of each

rule are available for public inspection at EPA's Region 9 office

during normal business hours. Copies of the submitted rule revisions

are also available for inspection at the following locations:

Rulemaking Section (A-5-3), Air and Toxics Division, U.S.

Environmental Protection Agency, Region IX, 75 Hawthorne Street, San

Francisco, CA 94105.

Environmental Protection Agency, Air Docket (6102), 401 ``M''

Street, S.W., Washington, D.C. 20460.

California Air Resources Board, Stationary Source Division, Rule

Evaluation Section, 2020 ``L'' Street, Sacramento, CA 92123-1095.

Placer County Air Pollution Control District, 11464 B Avenue,

Auburn, CA 95603.

Monterey Bay Unified Air Pollution Control District, 24580 Silver

Cloud Court, Monterey, CA 93940.

Santa Barbara County Air Pollution Control District, 26 Castilian

Drive B-23, Goleta, CA 93117.

Ventura County Air Pollution Control District, 669 County Square

Drive, Ventura, CA 93003.

Yolo-Solano Air Quality Management District, 1947 Galileo Court,

Suite 103, Davis, CA 95616.

FOR FURTHER INFORMATION CONTACT: Helen Liu, Air and Toxics Division,

Rulemaking (A-5-3), U.S. Environmental Protection Agency, Region IX, 75

Hawthorne Street, San Francisco, CA 94105-3901, Telephone: (415) 744-

1199.

SUPPLEMENTARY INFORMATION: This document concerns SBCAPCD Rule 337--

Surface Coating of Aircraft or Aerospace Vehicle Parts and Products,

VCAPCD Rule 74.13--Aerospace Assembly and Component Manufacturing

Operations, MBUAPCD Rule 416--Organic Solvents, MBUAPCD Rule 433--

Organic Solvent Cleaning, MBUAPCD Rule 434--Coating of Metal Parts and

Products, YSAQMD Rule 2.25--Metal Parts and Products Coating

Operations, YSAQMD Rule 2.33--Adhesives Operations, PCAPCD Rule 238--

Factory Coating of Flat Wood Paneling, submitted to EPA on January 24,

1995, April 5, 1991, July 13, 1994, September 28, 1994, September 28,

1994, November 30, 1994, November 30, 1994, and October 13, 1995,

respectively, by the California Air Resources Board. For further

information, please see the information provided in the Direct Final

action which is located in the Rules Section of this Federal Register.

Authority: 42 U.S.C. 7401-7671q.

Dated: November 8, 1995.

Felicia Marcus,

Regional Administrator.

[FR Doc. 96-2970 Filed 2-9-96; 8:45 am]

BILLING CODE 6560-50-P